Inertial Damper for Stepper Motors DMP - PHYTRON - #1

/ 2


catalogue search
Inertial Damper for Stepper Motors DMP - PHYTRON
P. 01
Inertial Damper for Stepper Motors DMP - PHYTRON
P. 02
Pages:
Inertial Damper for Stepper Motors DMP - PHYTRON


See other catalogues for PHYTRON

Text version of the page
AMBIENT DMP is an inertial damper for stepper motors. It delivers an excellent performance over a wide frequency because of its specific structure. This minimises settling times in the start-stop operating region and avoids system resonances. Thus, the DMP prevents not only vibrationinduced material fatigue and vibration-induced positioning errors, but also significantly reduces the acoustic noise. If certain perturbances are not adequately compensated for, the motor can lose steps. The resulting loss of torque and precision can drastically affect the application‘s performance. phytron‘s stepper motors run very smoothly due to their construction, hence a damper is not needed for most precision applications. However, should a Phytron motor operate in a resonance range, the damper is easily deployed to further enhance the motor‘s characteristics and stability. Application Greater requirements for smooth running and precision are often necessary, especially in optics. When moving samples or optics via a joystick, the improvements in the move quality for smoothness, very low acoustic noise and precision are visibly and audibly attained. Accurate and consistent movements with fast settling times of the driven system are significantly improved. DMP 20 / 29 / 37 Inertial Damper for Stepper Motors of Size 25 / 32 / 42 (NEMA 11 / 14 / 17) • Inertial damper for stepper motors size 25 / 32 / 42 (NEMA 11 / 14 / 17) • External diameter 20, 29 or 37 mm • Mounts onto shafts of 2,5; 3; 4; 5 mm or customised • Materials - Allows fitting to aluminium / plastic - Stainless steel fixing screws • Applicable standards - Protection class IP 62 (IEC 34) - Headless screws for mounting ISO 4027 (DIN 914/A2) • Environmental conditions - Ambient temperature 0 to +60 °C - Storage temperature -20 to +70 °C In Focus Shaft coupling Symmetric rational Load carrier Silicon gel Housing without damper with damper Decay Process Damper design www.phytron.eu ENG www.phytron.eu/DMP

pageCatalog pdf di En 2012-05-22-31