Text version of the page

Piezo

•

Nano

•

Positioning

Nanopositioning Controllers - 13949 E-505

LVPZT Piezo Amplifier Module

Ordering Information

Piezo Actuators E-505.00 LVPZT Amplifier Module,-20 to +120 V Nanopositioning & Scanning Systems E-505.00S Active Optics / Steering Mirrors Modified E-505.00 with one FixedVoltage of +100 V for tip/tilt Systems Ask about custom designs! Tutorial: Piezo- electrics in Positioning Capacitive Position Sensors
Piezo Drivers & Nano- positioning Controllers Hexapods / Micropositioning
E-505.00 Photonics Alignment Solutions

200 W Peak Power

Motion Controllers

Output Voltage Range -20 to +120 V II. External Control:

Ceramic Linear Motors & Stages

Output voltage is controlled byan analog signal applied to the BNC input ranging from -2 to+12 Volts. Multiplying by thegain factor of 10, an output voltage range of -20 to +120 Volts results. The DC-offset potentiometer adds a DC biasto the input, allowing continu- ous shifting of the input range between -2 V to +12 V and -12 V to +2 V (see page 6-52).For computer-controlled opera-tion, an E-516.I3, 20-bit DACinterface/display module can be used (requires E-500/ E-501 chassis). See graph for fre- quency response with selected LVPZTs. The E-505.00 is a piezo drivermodule for low-voltage PZTs. Itcan output and sink a peak cur-rent of 2000 mA and an aver- age current of 300 mA. The E-505.00 can be operated in two ways:

Index

I. Manual Control: Notes The output voltage can be setby a 10-turn, DC-offset po- tentiometer in the range of 0 to100 Volts. E-505.00 amplifier is not astand-alone device. It is de- signed to work in the E-500/ E-501 chassis (p. 6-18) with integrated power supply. A 32- pin connector is used to inter- face with the E-500/E-501 chas-sis.

Technical Data

ModelsE-505.00* FunctionPower amplifier Channels1Maximum output power200 W (see page 6-52) Average output power30 W Peak output current <5 ms2000 mA Average output current >5 ms300 mACurrent limitationShort-circuit proof Voltage gain10 ±0.1 PolarityPositive Control input voltage-2 to +12 V Output voltage-20 to +120 V DC-offset setting0 to 100 V at output with 10-turn pot. Input impedance1 M / 1 nF Control input socketsBNCPZT voltage output socket:LEMO ERA.00.250.CTL
E-505, frequency response with various PZT loads. Values shown are capacitance inµF, measured in actual PZT. DimensionsOne 14T slot wide, 3H highWeight0.9 kg Operating voltageRequires E-530/E-531 power supply (E-500/E-501 system)
© PI 1998-2005. Subject to change w/o notice. Cat 118 05/09.17 * E-505.00S with one fixed voltage of +100 V

6-25