Recommended panel thickness
DIMENSIONS
3.5 to 6mm
Note: drawings not to scale Recommended screw torque The JC400
industrial joystick has three options for
each mounting flange style, which include
through holes and thread inserts in the
4mm diameter holes. To maintain an
effective
industrial seal between the joystick flange
and the mounting panel, the mounting
screws should be tightened to a suitable
torque to match the selected attachment
screw size.
Round flange(codes A, C & E) 47Lever forward +Y - orientation mark on base
Lever right (+X)
4 holes (ø4)(or with inserts as order code) Rectangular flange(codes B, D & F) INSTALLATION
The joystick is designed to be fitted frombelow the mounting panel, through a
37mm x 37mm square hole. The
effectiveness of the joystick flange sealing is
dependent on the panel mounting surface
being sufficiently rigid to compress the
sealing gaiter. The surface finish of the
mounting panel is also critical to achieving
an adequate seal and rough surface
finishes, paint chips, deep scratches, etc.
should be avoided.
ø59.84 holes (ø4)on a PCDof 53 5337
3736
ø4 ZChandle shown(see page 19 foralternatives) Panelmountingdetails - round flange
Panelmountingdetails - rectangularflange 3753
57
3745 76 max
8
5.5358 ø4 R3 Pin 8
Pin 16 R3 39 ConnectionMating connector and pins kit (order separately) FCI DUBOX
TM 2 x 8 way male connector (76385-308)SA47363 (contains DUBOX
TM 65239-008, 65239-002 and 65239-003 femaleconnectors and pins 76357-301 suitable for AWG 22-30 wire size)Requires crimping pliers (FCI No. HT234) to fit pins to wires. DescriptionConnector Pin Number Y axis switch 13
Y axis switch 214
Y axis switch 316
Y axis signal N/O (lever forward +Y)9
Y axis signal N/O (lever backward -Y)1
Y axis switch track common5X axis switch 14X axis switch 27
X axis switch 310
X axis signal N/O (lever right +X)2
X axis signal N/O (lever left -X)6
X axis switch track common5
16