Ω at 50Vdc*The long life resistive elements require a high impedance load in the wiper circuit to minimisethe current flowing through the wiper for optimum life conditionsNot available with CANbus output1.5 or 5 either side of center 35 200 resistiveAll primary potentiometer track and directional/center switch connections terminate in a 16-wayAMP 040 series multi-lock connector specifications in the industrial joystick base. Secondary potentiometer track connections terminate in an 8-way AMP 040 series multi-lock connector. See page 8 for pin identitiesSA47931 (AMP 040 16 way connector 174046-2; Pins 175062-1) P49780 (connector, pins and 380mm long cable) SA304522 (AMP 040 8 way connector 174044-2; pins 175062-1) P303083 (connector, pins and 380mm long cable)Not available with CANbus outputTwo switches per axis. Normally open at lever center position 2 to 5 either side of center 3A @125Vac, 2A @ 30Vdc 100,000 cycles, cycled at 1Hz, 1A and 12Vdc -25 to +85Microswitch connections in the potentiometer joystick will replace the low currentdirectional/center switches in the 16-way AMP 040 series multi-lock connector in the joystick base. In the Hall sensor joystick, switches terminate in the 8-way connector. See Electrical Connections on page 8 for pin identitiesJC6000 with Hall sensing option can also be supplied with an integrated CANBUS outputoffering the J1939 protocol. This CANBUS interface meets the requirements of IEC61508 SIL level 1 9 to 36 CAN 2.0b J1939 IP66 IEC60529All connections terminate in the 6-way Deutsch DTM04-6P integrated connectorP304844 (includes 390mm flying leads)

ELECTRICAL -POTENTIOMETER TRACK

ResolutionTrack resistance ±20% k Virtually infinite1.8, 2, 2.9, 5 ±18 0-100, 10-90, 25-75 of input 48 - 52 of applied voltage ±2.5 Within 0.5 32 1 minimum recommended*0.25 Greater than 15M Ω Track operating angleº Output voltage range% Center tap voltage% Center tap angleº Center tap to switch alignmentº Supply voltage maximumVdc Wiper circuit impedance M Ω Power dissipation @ 25°CWInsulation resistance

ELECTRICAL -DIRECTIONAL OR CENTER SWITCH (LOW CURRENT)

Switch operating angleºSupply voltage maximumVdc Load current maximummA

ELECTRICAL CONNECTIONS

Mating 16 way connector and pinsMating 16 way harness Mating 8 way connector and pins Mating 8 way harness

ELECTRICAL -MICROSWITCH

Switch configurationSwitch operating angleº Contact rating Switch life minimum Operating temperatureºC

ELECTRICAL CONNECTIONSCAN OUTPUT VERSION

Supply voltage range VdcCAN version Protocol Under-panel sealing

ELECTRICAL CONNECTIONS

Mating connector and pins

5