| APPLICATION NOTES : </ The cables are made of PU, class 6, suitable for cable-guiding industrial chains, 2m standard length, copper X-sectlon area according to rated current. </ Rotor/housing alignment (P) must be accurate to within +/- 0.1 mm. Optionally, we can supply a mounting tool for achieving this alignment when assembly without accurate alignment is impossible. </ Thermal device cable consists of a shielded pair 2x0.14mm2 section, 4mm external diameter. </ (De) represents: 1- The maximum diameter passing inside the housing. 2- The maximum diameter necessary for rotor assembly. </ (Pmax) diameter for components in contact with the rotor must never be exceeded. </ Tapped holes on each side of rotor and housing are angularly aligned. </ Cable positioning (AF) is theoretical. Leave a free area with a +/- 10 degree tolerance around this position, at a 30 mm height from the side of the housing, to avoid applying excessive force to the motor cables. </ When designing the assembly, take care to ensure perfect contact between the housing and user's bore to avoid thermal problems. </ For mounting the housing, use either external the centering diameter (B) or internal centering diameters (A). </ For assembly tolerances (perpendicularity, concentricity...), please consult us. </ Fluid input and output pipes must be aligned with the cable output. </ O-ring grooves are designed for 4 mm diameter o-rings </ Dimensions in brackets ( ) for P, LB, J4 and E3 are 40mm wider when the nominal current is greater than 72A (4 single wire outputs). |