Brushless DC motor with driver for front panel installation and AC operating voltage - BLU Series - Orientalmotor - #1

Text version of the page

Tonon ForMe Catalogue table.main {} tr.row {} td.cell {} div.block {} div.paragraph {} .font0 { font:4.80pt "Arial", sans-serif; } .font1 { font:5.00pt "Arial", sans-serif; } .font2 { font:7.00pt "Arial", sans-serif; } .font3 { font:8.00pt "Arial", sans-serif; } .font4 { font:10.00pt "Arial", sans-serif; } .font5 { font:11.00pt "Arial", sans-serif; } .font6 { font:20.00pt "Arial", sans-serif; } .font7 { font:4.00pt "Impact", sans-serif; } .font8 { font:5.00pt "Impact", sans-serif; } .font9 { font:5.00pt "Tahoma", sans-serif; } .font10 { font:39.00pt "Verdana", sans-serif; } c (0 l e (0 (0 a o (rôhs) RoHS-Compliant Brushless DC Motor and Driver Package BLU Séries •Additional Information* Technical référence -» Page F-1 Safety standards — Page G-2 o O The BLU Séries combines a brushless DC motor and a panel-installation type driver, enabling speed control via simple wiring and easy operation. Choose a parallel gearhead, or a hollow shaft flat gearhead that saves installation space on your equipment. List of safety standard approved products (Model, Standards, File No., Certification Body) — Page G-10 ■Features • Easy Connection, Easy Operation The motor can be connected simply by plugging the connector into the driver. There is no need for troublesome wiring. The motor speed can be set using the potentiometer on the front panel. • Long Life Gearhead Rating of 10000 Hours The rated life of the parallel shaft gearhead and hollow shaft flat gearhead is 10000 hours. The parallel shaft gearhead achieves a rated life of twice as long as that of a conventional gearhead. • The 90 W parallel shaft gearhead has a tapped hole at the shaft tip. • Features of Hollow Shaft Flat Gearhead <<Space-Saving and Low-Cost The output shaft can be coupled directly to a drive shaft without using a coupling. The flexible installation modes, such as installation on either the front or rear face or by using the center shaft, allow you to reduce the size and installation space of your equipment. Since no shaft-coupling parts are needed, the parts cost and labor will also decrease. Parallel Shaft Gearhead Hollow Shaft Flat Gearhead • External Control Possible Start/stop, rotation direction switching and instantaneous stop can be controlled using external signals. You can also switch between the source logic and sink logic in accordance with the output type of your controller. • Speed Control Range 100 to 2000 r/min (speed ratio 1:20) • IP65 Motor Structure The motor is protected against water intrusion, should water come into contact with the motor. • The motor must not be washed with water, and is not suitable for use in an environment where it constantly comes into contact with water. •(RÔÏJD RoHS-Compliant The BLU Series conforms to the RoHS Directive that prohibits the use of six chemical substances including lead and cadmium. • Details of RoHS Directive — Page G-23 Coupling Co Gearhead I Space Saved Motor <<High Permissible Torque While the permissible torque of the parallel shaft gearhead saturates at high gear ratios, the hollow shaft flat gearhead enables the motor torque to be fully utilized. E a 80 H illow Shaft Flat Gearhead Parallel Shaft Gearhead 1 0 2( Gear Ratio 0 40 Q. 20 0 Features B-34 / System Configuration B-35 / Product Line B-37 / Spécifications B-38 ORIENTAL MOTOR GENERAL CATALOGUE