| Image screen is not renewed. A The image right after the switch operation is not displayed when SYNCHRO (synchronous input) is set to "1" or "3." The judgment output signal is normal even though an image is not displayed. • Set SYNCHRO to "0," "2," or "4" if there is no problem. Noise image is displayed at the left edge of the image screen. A When SYNCHRO (synchronous input) is set to "1" or "3," the column to be displayed at the very right on the screen is displayed at the left end; the judgment input signal is normal. • Set SYNCHRO to "0," "2," or "4" if there is no problem. Brightness of the screen right after the bank is switched is inadequate. A An image displayed right after the bank is switched to the one for the different image-taking zone, and the brightness of the screen differs from that of the original screen. ■ Set SYNCHRO (synchronous input) to "0," "2," or "4" if there is no problem. • Take a dummy image and use it for judgment. "X" is displayed on the screen regardless of the area that turns ON the output signal. A Actual output may not be ON yet since the set value of ONDLY (ON delay) is great. • Wait until the ON delay time. A One-shot output signal may be complete since ONESHOT (one-shot) is set to "1." • Change ihe OFF conditions to (he ON conditions again, and confirm that the output signal turns ON. • Increase the set value of OFFDLY (OFF delay) to lengthen the ON time. |