| fa 2-point teaching is executed when is pressed while teaching is performed. • Pressing for 3 seconds or more will enter the set value. Teaching mode is switched to the 2-point teaching if hand is released from [SET] button within 3 seconds Therefore, confirm whether or not "TCH LOW" is displayed in the screen in case when hand is released from button within 3 seconds by mistake. "TCH LOW" displayed in the screen shows that the present teaching mode is the 2-point teaching mode. In such a case, press again to restore the 1-point Teaching mode. tr, Color cannot be detected when the device is used for a while. fak TEMPCMP (temperature compensation level) may be an improper value. • Normally set it to "30." When the color shifts, detection becomes successful by adjusting this value. (However, this is effective only when RESOLUT is set to "1" and COLRFIL is set to "0" or "2.") fak The set value of COLOR% (color margin) may be small. • Making this value greater will widen the color detection range. • In order to widen the detection range on teaching, increase the set value of TEACH% (teaching color margin). tr, Other colors are detected when the device is used for a while. fak TEMPCMP (temperature compensation level) may be an improper value. • Normally set it to "30." When the color shifts, detection becomes successful by adjusting this value. (However, this is effective only when RESOLUT is set to "1" and COLRFIL is set to "0" or "2.") fak The set value of COLOR% (color margin) may be great. • Making this value smaller will narrow the color detection range. • In order to narrow the detection range on teaching, decrease the set value of TEACH% (teaching color margin). |