Catalogues - color-identity-sensor

Catalogue Color Identity Sensor

www.optex-fa.com

Page

/ 48

Contact the
Manufacturer

Where to buy
this product ?

Request
a Quote

/ 48

See other catalogues for Optex FA

Text version of the page

Function name

Setting range (Initial value)

Explanation

LCD display

Sets the fineness of the pixels taken out of the image transducer.

0 : High resolution mode (240 x 200)

1 : High speed mode (240 x 100); Set to

increase the response time, leaving the view range as is.

Resolution*^É

0, 1 (1)

RESOLUT

Sets the delay time of a synchronous input signal. Delays only by the time obtained by multiplying a synchronous input signal by 64 microseconds of the set value. Used to make a fine adjustment of the image-taking timing.

Synchronous input | delay time

0 - 255

(0)

SYNCDLY

Sets a synchronous input signal. When set to "0" to "3" the bank switch 3 input becomes invalid. Also, the response time becomes constant at the time twice the standard transfer time.

0 : Takes image continually while a synchronous input signal is OFF. Takes image when a synchronous input signal is switched from ON to OFF.

2 : Takes image continually while a synchronous input signal is ON.

3 : Takes image when a synchronous input signal is switched from OFF to ON. Invalidates synchronous input signal (Image is always taken.)

Synchronous input*⁷

0 - 4 (4)

SYNCHRO

*6: Brightness changes when RESOLUT is changed. In such a case, perform teaching again. Note that the output signal may turn ON/OFF momentarily when this set value is changed.

*7: • When SYNCHRO is set to "1" or "3" one image taken immediately after the switch is operated is not displayed. However, the judgment output signal is effective. Also, the right-most column in the screen is displayed at the very left. This is only a problem of the screen display, and image is displayed normally when an image is taken.

• When SYNCHRO is set to "0" or "2" and the bank switch 3 input width (0 is OFF width, 2 is ON width) is less than the response time, an image is displayed on the screen (including present area) once per twice, but the output signal is renewed every time.

• When SYNCHRO set value is changed, an image may remain on the image screen. The screen is displayed normally when the screen is renewed by taking an image.