Catalogues - color-identity-sensor

Catalogue Color Identity Sensor

www.optex-fa.com

Page

/ 48

Make a request

/ 48

See other catalogues for Optex FA

Text version of the page

Function name

Setting range (Initial value)

Explanation

LCD display

Sets the color filter.

: Converts the color ratio per each pixel.

: Acquire the maximum luminance (brightest point) according to RGB in the four right - most columns, and correct the brightness of each pixel by the value. Used only when detecting the difference in the color shades such as the difference between black and gray, etc.

: High sensitivity mode of "0." Used to shorten the shutter time. 3 : High sensitivity mode of " 1." Used to shorten the shutter time.

Color filter*⁴ *

0 - 3 (0)

COLRFIL

Sets the hysteresis (0.1% unit of all pixels) of the area upper and lower limits. When the area immediately before detection is within the detection area range, the value obtained by adding the set value to the area upper limit number of pixels and the value obtained by subtracting the set value from the area lower limit number of pixels become the area upper and lower limits respectively.

Area hysteresis

0 - 200 (10)

HYSTRSY

Sets the time constants of the bank switching signal and the external teaching signal. 0 : 128 - 192us 1 : 2 - 3ms

2 : 4 - 6ms 3 : 6 - 9ms

4 : 8 - 12ms

Input constant

0 - 4 (4)

IN FILT

Sets the ratio to correct the color darkness. Any correction is not made when set to "0" and the maximum effect (to amplify "black" to convert to other color) is obtained when "31 " is set. Greater set value is likely to make a darker color a noise element, and smaller set value induces more influence from turbulence light.

Darkness correction factor*¹*

0 - 31 (27)

KIL BLK

*1: Set value changes when the bank is switched.

*4: A white reference object is necessary at the four right-most columns in the screen.

The whole brightness should be adjusted based on this section. *: Patent is being applied.