Text version of the page 
Tested to and Passed the Following Performance Specifications
Current Rating: 3amps max Dielectric Withstanding Voltage: 600 VAC RMS Insulation Resistance: 5000 Megohms min @ 500 VDC Contact Resistance: 26 milliohms (65 mv) max @ 2.5 amps Contact Engagement/Separation Force :Engagement forces not to exceed 6 ozSeparation forces shall not be less then 0.5 oz Temperature Cycling: -55 Cto+125 C,5cycles Humidity (Mated): IAW MIL-STD-1344, Method 1002.2, Type II, Omit steps 7A & 7B Vibration: IAW-MIL-STD-1344, Method 205.1, TestCondition IV, 20 g’s Mechanical Shock: IAW-MIL-STD-1344, Method 2004.1, TestCondition E, 50 g’s Durability: 500 cycles Contact Resistance after Durability: 26 milliohms (65 mv) max @ 2.5 amps Mating/Unmating after Durability: Forces not to exceed 6 oz/contact Salt Spray: 48hrs IAW-MIL-STD-1344, Method 1001.1, Test Condition B Low Level Contact Resistance after Salt Spray:28 milliohms max (2.8 mv) max @ 100 milliamps Contact Resistance after Salt Spray:28 milliohms (70 mv) max @ 2.5 amps Mating/Unmating force after Salt Spray: Forces not to exceed 6 oz/contact Contact Retention after Salt Spray: Minimum of 5 lbs contact retention Thermal VacuumOutgassing: NASA SP-R-0022 Solder Heat & Contact Retention: 360 Cfor10sec. & contacts must withstand 5lbs retention force Solderability: MIL-STD-202, Method 208 Forces as measured using minimum and maximum diameter test sleeves.
INFORMATION SHOWN IS SUBJECT TO CHANGE WITHOUT NOTICE Page 1-5 7260 Commerce Circle East • Minneapolis, MN 55432-3103 • Ph: (763) 572-0656 • www.omnetics.com