catalogue search
P. 01
P. 02
P. 03
P. 04
P. 05
P. 06
P. 07
P. 08
P. 09
P. 10
P. 11
P. 12
P. 13
P. 14
P. 15
P. 16
P. 17
P. 18
P. 19
P. 20
P. 21
P. 22
P. 23
P. 24
P. 25
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You may also be interested in
EMI gasket, EMI shielding, Finger-stock, Seal, Shielding
Text version of the page
® B B u u l l l l e e t t i i n n N N o o : : 1 1 2 2
INSTALLATION GUIDELINES Part 2 STORAGE AND INSTALLATION INSTRUCTIONSFOR PRODUCTS CONTAINING INSTANT TAC OR CONDUCTIVE TAC TRANSFER ADHESIVE TAPESSTORAGE Shielding strips containing a transfer adhesive should be stored at a temperature of70°F or lower. INSTALLATION Shielding strips should only be applied to a smooth, clean and dry mounting surfaces at room temperature (65° to 75°F). 1-2-3 Installation: 1.Smooth the mounting surface with an emery cloth, if necessary, and clean with asuitable commercial solvent to remove all oils or film. Avoid fingerprints on the mounting surface after cleaning.2.Peel off the protective paper backing and avoid finger contact with the adhesive. 3.Make certain that the strip is in the correct position and then press down firmly to insure a good bond over the entire mounting surface. Avoid any re-positioning after the strip is in place, for this will reduce the effectiveness of the adhesive and may distort the strip. Allow 24 hours for complete "curing" time. OMEGA SHIELDING PRODUCTS, INC.9 Emery Avenue Randolph, NJ 07869Tel: 973-366-0080 1-800-828-5784 Fax 973-366-8232 URL: www.omegashielding.com/ EMAIL: sales@omegashielding.com
INSTALLATION GUIDELINES Part 2 STORAGE AND INSTALLATION INSTRUCTIONSFOR PRODUCTS CONTAINING INSTANT TAC OR CONDUCTIVE TAC TRANSFER ADHESIVE TAPESSTORAGE Shielding strips containing a transfer adhesive should be stored at a temperature of70°F or lower. INSTALLATION Shielding strips should only be applied to a smooth, clean and dry mounting surfaces at room temperature (65° to 75°F). 1-2-3 Installation: 1.Smooth the mounting surface with an emery cloth, if necessary, and clean with asuitable commercial solvent to remove all oils or film. Avoid fingerprints on the mounting surface after cleaning.2.Peel off the protective paper backing and avoid finger contact with the adhesive. 3.Make certain that the strip is in the correct position and then press down firmly to insure a good bond over the entire mounting surface. Avoid any re-positioning after the strip is in place, for this will reduce the effectiveness of the adhesive and may distort the strip. Allow 24 hours for complete "curing" time. OMEGA SHIELDING PRODUCTS, INC.9 Emery Avenue Randolph, NJ 07869Tel: 973-366-0080 1-800-828-5784 Fax 973-366-8232 URL: www.omegashielding.com/ EMAIL: sales@omegashielding.com