OMAX® 80X JetMachining® Center - OMAX - #1

Text version of the page

PRECISION ABRASIVE WATERJET SYSTEMS Equipment Specifications 80X Series OMAX® 80X JetMachining® Center Standard Features • OMAX Intelli-MAX® software offers higher average cutting speeds and greater precision with free upgrades for the life of the machine • Programmable Motorized Z-Axis with precision OMAX MAXJET®5i Nozzle Assembly • Ball screw drive inside the Y-axis bridge fully enclosed inside bellows* • Intelli-TRAXTM traction drive inside the X-axis beams fully enclosed inside coated steel covers • Scissor-style hard plumbing • Component protection against water, dirt, and grit • High efficiency direct drive pump systems available in 30, 40, and 60, 70 and 80 hp with pressures up to 55,000 psi and 60,000 psi • Rapid Water Level Control for quiet and clean submerged cutting • Bulk Abrasive Feed Assembly transports garnet from the assembly’s large hopper into the small hopper located at the Z-axis • Solids Removal System (SRS) designed for tough industrial use (available as an option) • Tilt-A-Jet® taper compensating abrasivejet cutting head (available as an option) • Shipped as a completely pre-assembled and factory-tested system Abrasivejet Benefits • Machines a wide range of materials and thicknesses • Does not create heat-affected zones or mechanical stresses • Rapid setup, no tool changes required • Minimal fixturing required • Leaves behind a satin-smooth edge, reducing secondary operations • No noxious gases, liquids or oils used in (or caused by) the machining process • Completes most work below 80 dBA at 1 meter for submerged cutting • Environmentally “green” system with quiet and clean operation, low electrical and abrasive consumption The OMAX Technology Guarantee entitles you, as the original owner, to free OMAX software upgrades for the life of the machine. Connect and follow OMAX for the latest news in waterjet technology. C o r p o r a t i o n Machine Dimensions Footprint (with controller) 265" x 152" (6,731 mm x 3,861 mm) Weight (tank empty) 9,000 lbs (4,082 kg) Height (with scissor plumbing) 144" (3,658 mm) Operating Weight 34,000 lbs (15,422 kg) Work Envelope X-Y Cutting Travel 165" x 80" (4,191 mm x 2,032 mm) Table Size 180" x 89" (4,572 mm x 2,261 mm) Material Support Slats 4" x 1/8" Galvanized Steel Maximum Supported Material Load 400 lbs/sq ft (1,950 kg/sq meter) (Optional accessories may reduce travel. Contact OMAX for information.) Drive Description • Closed loop, digital drives • Brushless servo motors • Pre-loaded ball screw with recirculating ball bearings and hardened precision ground ways in Y-axis bridge • Intelli-TRAX Drive with linear encoder in X-axis • Motor controlled precision Z-axis Speed • 180 inches per minute standard (4,572 mm/min) 80X Series * 80X-2 model equipped with Intelli-TRAX Drive System and linear encoder completely enclosed inside covers (see reverse).