Autoclave Glass Lamination - OLMAR - #2

0

water exit

L

security

security

air intake

pressure discharge

security door

motor and turbine

envelopes

■ Glass lamination, depending on the industry, is achieved by heating air inside the equipment, either by means of electric strengths, either by means of steam or thermal oil through a heat-exchanger. A powerful electric fan circulates the inside air, thus allowing for the achievement of temperature values inside the equipment with minimal variations from one point to another. Cooling is achieved by circulating cold water or cooling fluids, through a purpose-designed exchanger with forced ventilation inside its plates, diminishing the inside temperature of the desired values.

heating system

Лаке [)НМЬИЙ

vacuum pump

r

All the reffered process, as may be varied and/or repeated depending on the industry is used for and the procces to be carried out, will be developed in a completely automatic way. A microprocessor will be in charge of receiving the inputs that, during the cycle, will be transmitted by the data receivers, immediately sending commands to the relevant valves and actuators so that they can regulate the process as per the preset data. There is the possibility to include internal probes informing us in real time about the pressure/vacuum and/or temperature values of the product under treatment. As one could image, should any anomaly occur during the process, the equipment will release the relevant alarms for the system failure or, in the event of fluid supply, for the immediate action in order to correct the problem.

On this respect, it is very important to point out that our equipment, as an option, may have independent connections for a different number of vacuum bags to be put inside the autoclave. This, together with the supply of nitrogen or compressed air in order to be able to regulate pressure according to the requirements of the product to be treated, allows for the equipment to be fully independent for the regulation of the necessary pressure/vacuum grades. In the same way, variables in different points in the autoclave and in the pieces inside are controled by means of thermocouples and sensors.