Catalogues - wg-series-gripper - numatics-motion-control

Catalogue WG Series Gripper

www.numatics.com

Page

/ 8

Contact the
Manufacturer

Where to buy
this product ?

Request
a Quote

/ 8

See other catalogues for NUMATICS

Text version of the page

WG Series Parallel Gripper Double Guided Wedge

WGS-50 Parallel Gripper Double Guided Wedge

Gripper summary of Operation:

Synchronous motion is achieved with a double acting piston attached via the piston shaft to a double sided wedge. The double sided angles of the wedge convert vertical motion to synchronous horizontal motion of the jaws.

H. DOt

Hardcoat Anodized Teflon impregnated aluminum inside and out. Ultra high gripping force to weight ratio.

B. Jaws

Jaws machined from S7 tool steel to prevent jaw breakage.

C. Switches

Proximity switches are available to monitor open and closed position of the jaws.

D. Side Ports

Additional side mounting holes and side air ports for optional mounting and porting.

E. Lubrication

Units are permanently lubricated for non-lube air operation, this allowing for compliance with OSHA regulations.

WGL-50 Long Stroke and WGS-90 Short Stroke Parallel Grippers Double Guided Wedge

Gripper summary of Operation:

A. Body

Hardcoat Anodized Teflon impregnated aluminum inside and out. Ultra high gripping force to weight ratio.

B. Jaws

Hardcoat Anodized Teflon impregnated aluminum. Lightweight, Durable, high strength.

C. Purge Port

Unit can be slightly pressurized to prevent debris or coolant from entering. A vacuum can be applied q to evacuate contaminants from inside the unit in a clean room environment.

D. Switches

Proximity switches are available to monitor open and closed position of the jaws.

Information subject to change without notice. For ordering information or regarding your local sales office visit www.numatics.com.