V60-63 Drawing dimensions

33D Front view Rear view (flange version)

OUT1HYSWINOUT2

SET

Incorporating

14 30

Suitable for M 5 x 35screws

30 G1/4 female Suitable for M 5 screws Flange diameter 8 x 1.2 deepO-ring 5 x 1.5 (NBR) Pneumatics O-ring 4.47 x 1.78 (FKM) Hydraulics/Allfluid Rear view(Flange version)Front viewM 12 x 111.522 20

Flange diameter 8 x 1,2 deep O-ring 5 x 1,5 (NBR) PneumaticsO-ring 4,47 x 1,78 (FKM) Hydraulics

18S18D

30 30

30 75 20 30

14

20 15 15

O-ring 5 x 1.5

Pg 11 Ø 8 x 1,2 deep ø 8 x 1.2 deep O-ring5 x 1,5O-ring5 x 1,5 O-ring 5 x 1.5

System designers must provide a warning to end users in thesystem instructional manual if protection against a failure mode cannot be adequately provided.

Warning

System designers and end users are cautioned to review specificwarnings found in instruction sheets packed and shipped with these products. These products are intended for use in industrial compressed airsystems only. Do not use these products where pressures and temperatures can exceed those listed under ‘Technical Data’ .Before using these products with fluids other than those specified, fornon-industrial applications, life-support systems, or other applications not within published specifications, consult NORGREN.Through misuse, age, or malfunction, components used in fluid powersystems can fail in various modes. The system designer is warned to consider the failure modes of all component parts used in fluid powersystems and to provide adequate safeguards to prevent personalinjury or damage to equipment in the event of such failure.

N/UK 5.4. 314.20

Our policy is one of continued research and development. We therefore reserve the rightto amend, without notice, the specifications given in this document.

5/02