| | | • All IEC standard motors with B14 or B5 flanges are mountable using an adapter. • Because of the tooth coupling of IEC adapters, you need only one basic worm gear unit design for all IEC standard motors. • It is suitable for all mounting positions because of the hermetic seal and separate oil chambers for each gear unit stage. • There is a large gear ratio range from i=5 to over 10000 because of the helical prestage module and the double worm gear unit. • Various insert shafts for the output end hollow shaft. • Various screw-on B5 output flanges and a torque arm. • Free drive shaft with the basic worm gear unit design is possible using the free drive shaft module type W. • High capacityof reaction on site because of easily exchangeable modules without opening the oil chambers. • A varietyof drive variation with few different possible modules. Immediately Available • The fastest availabilitysince the mounted, ready-to-use modules and are kept readyin store. | | • Economicallyproduced with optimal installation of the modules in large quantities. Simple Processing • Ordering with modules using order numbers is clear and easy. - Mounting position is not required. Available as Modules or as Assembled Units • UNIVERSAL worm gear units and drive motors available as modules - Mounting position not required - High on site flexibility - Low inventorylevel with a high number of variants - Ready-to-use modules packed with all small parts - Easilyinsertable modules that are easilyassemble with screws. • UNIVERSAL worm gear units and drive motors also available pre-assembled. - Practical with often repeated variants. - Mounting positioin required (see page 8). | | |