Text version of the page

www.norbar.com Handtorque™ Multipliers What is a Torque Multiplier?

Atorque multiplier is a device that increases the torque that can be applied by an operator.Because the power output can not exceed the power input,the number of output revolutions will be lower than the number of input revolutions (Torque x rpm = Power).

How Handtorque Torque Multipliers Work

Handtorque multipliers incorporate an ‘epicyclic’ or ‘planetary’ gear train having one or more stages.Each stage of gearing increases the torque applied by a factor of 5,allowing Norbar to offer multipliers typically in ratios of 5:1,25:1 and 125:1.In the planetary gear system,torque is applied to the input gear or ‘sun’ gear.Three or four planet gears whose teethare engaged with the sun gear therefore rotate.The outside casing of the multiplier,or ‘annulus’ is also engaged with the planet gear teeth,and would normally rotate in the opposite direction to the sun gear.A reaction arm prevents the annulus from rotating,and this causes the planet gears to orbit around the sun.The planet gears are held in a ‘planetary’ carrier which also holds the output square drive.Therefore as the planet gears orbit around the sun gear, the carrier and so the squaredriveturns.Without the reaction arm to keep the annulus stationary,the output square will not apply torque.

Why use a Handtorque Torque Multiplier?

• Safety –use of long levers can be dangerous.Torque multipliers mean a reduction in the lever length or operator effort by a factor of 5,25 or 125.• Space limitation –the use of a long lever may be impossible due to the available space.• Accuracy –torque will be applied most accurately when it is applied smoothly and slowly.Torque multipliers enable this by removing much of the physical effort from the tightening task.
TorqueVelocity Without a torque multiplier With a torque multiplier 25 revolutions Output 2500 N.m0.84 revolutions Input 100 N.m

26

Norbar ®
-your key to torque control