| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |
| | | |
| | | Sample Holders | | |
| | | |
| | | Sample holder for expansion and penetration measurements The probe for penetration measurements has an extended flat tip of 1 mm 0 Sample Holder Sample length: Sample diameter Material: Thermocouple: Temperature range Optional probes | | |
| | | The sample lies on a cylindrical body made of the same material as the probe and sample holder. | | Expansion and penetration measurement Probe | | |
| | | |
| | | |
| | | Thermocouple Penetration tip Sample | | |
| | | Standard 50 mm max. 9 mm max fused silica type E or S -150. 500°C/25 1000 °C penetration. dyn elasticity (max 250 °C) | | |
| | | |
| | | |
| | | |
| | | Sample holder for measurements under tension The sample to be tested (fibers, films) is held between two clamping devices | | Measurement under tension | | |
| | | The measurement under tensile load is done via the tension probe, through which the load is also transmitted. | | |
| | | |
| | | |
| | | |
| | | Clamping device Thermocouple Sample Tension probe Clamping device | | |
| | | Sample Holder Clamping device Material Thermocouple: Temperature range | | |
| | | Tension Measurement accessory for different sample geometries (fibers, film) fused silica type E -150 350 °C | | |
| | | |
| | | |
| | | |
| | | Sample holder for bending measurements The sample is positioned on two edge supports and the bending is Sample Holder Sample length Sample diameter Support distance: Material Thermocouple Temperature range | | measured with a knife-shaped probe through which the load is applied. | | Bending measurement | | |
| | | |
| | | |
| | | Sample holder Loading probe Thermocouple Sample Supports | | |
| | | Bending Measurement I (II) 16 mm (30 mm) 5 mm max 12 mm (20 mm) fused silica type E or S (Type E) -150 500 °C (-150 500 °C) 25 1000 °C | | |
| | | |
| | | |
| | | |
| | | 5 | | |
| | | |
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |