Catalogs >
NACHI-FUJIKOSHI CORP. >
AG Power Drills, AG Power Long Drills

AG Power Drills, AG Power Long Drills
8Pages

Catalog excerpts

AG Power Drills, AG Power Long Drills - 1

Fast-feed high performance HSS drill I LO mJ AG Power Long Drills

AG Power Drills, AG Power Long Drills - 2

AGPSD AGPLSD High-performance and consistent production through a flute shape that combines both good rigidity and chip ejection. AG coating with superior heat resistance and durability increases tool life. Introducing the new AG power drills in regular size Gutting Soeec Deoth BlinO hole Non step Work materia FeeO Cutting Fluid Wet | Comparison of non-step drilling of tempered alloy steel Wear comoarison after 204 hole drilling Tool Feed Work materia Gutting Soeed Deoth Blind hole Non steo Cutting Fluid Wet AG Power Long Drills can drills to 20 L/D without stepping | Comparison of cutting...

Open the catalog to page 2

AG Power Drills, AG Power Long Drills - 4

1 )The table values are for drilling with water soluble cutting fluid 2) Provide sufficent amount cuutting fluid to the cutting point and in the flute 3) In non water soluble cutting fluid, reduce the rotation and feed by 20% 4)LJse the table values for drilling depths under 5XD 5) When for hole depth more then 5XD, reduce the rotation and feed by 20% 3) When for hole depth more then 5XD deep, add step seediing However, a work material and drilling condition to Chip removal may be worse n that case, add A even if drilling depth 5XD is as follows 7) In step feed, return to the entrance hole...

Open the catalog to page 4

AG Power Drills, AG Power Long Drills - 5

^^^A1 %S AG Power Long Drills

Open the catalog to page 5

AG Power Long Drills

Open the catalog to page 6

AG Power Long Drills OAdjust drilling condition according to the rigidity of machine or work clamp 2)The table values are for drilling with water soluble cutting fluid 3) Provide sufficent amount cuutting fluid to the cutting point and in the flute 4) In non water soluble cutting fluid, reduce the rotation and feed by 20% 5)LJse the table values for drilling depths under 20XD 3) When for hole depth more then 20XD reduce the rotation and feed by 30% 7) When for hole depth more then 1 7XD deep, add step seediing However, a work material and drilling condition to Chip removal may be worse n...

Open the catalog to page 8

AG Power Drills, AG Power Long Drills 8Pages

Catalog excerpts

All NACHI-FUJIKOSHI CORP. catalogs and technical brochures

AG Power Drills, AG Power Long Drills
8Pages