AG-ESS DRILL?AG-ES DRILL
4Pages

{{requestButtons}}

Catalog excerpts

AG-ESS DRILL?AG-ES DRILL - 1

AG-drill series which spreads. Recommend AG-SUS drills in stainless steel drilling. Recommend AG-power long drills deep hole drilling. The new alloy HSS drill is approached to the carbide drill AG-ESS DRILL AG-ES DRILL

Open the catalog to page 1
AG-ESS DRILL?AG-ES DRILL - 2

High-speed and high-feed, long tool life which is approached to the carbide drill. AG-ESS DRILL AG-ES DRILL The chip proves the good quality of sharpness High efficient drilling like the carbide drill ■It is high-speed/longer tool life/high reliability/low cost. ■High alloy HSS of new development new AG coating best match. ■Although being the melting HSS, longer tool life it exceeds the powder HSS. ■It realizes high speed drilling equal to carbide drill with reliability only by HSS. Competitor powder HSS coated drill compared to 30% longer tool life. WM'MSS. 60m/min inSS 19mm WMMM zK^tt...

Open the catalog to page 2
AG-ESS DRILL?AG-ES DRILL - 3

AG-ESS DRILL StanderdDrilling Conditions Attention on using the drilling condition tables 1 .Utilize the standard drilling condition shown in the catalogsjust as the general guide, when starting operation. 2.Adjust drilling condition when unusual vibration, different sound occur by cutting 3.When using low speed machines, use the maximum speed and adjust the feed rate 4.As for the below table, it is the values when it is lubricated fully with the vertical machine. In horizontal machine or deephole, use step feed 5.After grinding please lower drillng condition.

Open the catalog to page 3
AG-ESS DRILL?AG-ES DRILL - 4

AG-ES DRILL StanderdDrilling Conditions Attention on using the drilling condition tables 1 .Utilize the standard drilling condition shown in the catalogsjust as the general guide, when starting operation. 2.Adjust drilling condition when unusual vibration, different sound occur by cutting 3.When using low speed machines, use the maximum speed and adjust the feed rate 4.As for the below table, it is the values when it is lubricated fully with the vertical machine. In horizontal machine or deephole, use step feed 5.After grinding please lower drillng condition.

Open the catalog to page 4

All NACHI America catalogs and technical brochures

  1. MC350

    2 Pages

  2. DURO-V5

    2 Pages

  3. Micron Hard

    4 Pages

  4. Pre-Harden

    8 Pages

  5. MACHINE TOOLS

    28 Pages

  6. AG-mill Series

    20 Pages

  7. GS MILL Series

    44 Pages