RS Series Low-profile Gearhead - 8 Pages

  1. P. 1

  2. P. 2

  3. P. 3

  4. P. 4

  5. P. 5

  6. P. 6

  7. P. 7

  8. P. 8

Catalogue excerpts

(1) The hollow construction allows cables to pass through the reduction gear. (2) The servomotor shaft (input shaft) is positioned at a right angle to reduce the height from the base. (3) RS series gears can be installed with servomotors for most manufacturers. (4) All RS series gears are provided pre-greased. (5) The use of a specialized input spline and motor ange means motors can be easily attached and detached. High reliability High rigidity High precision The double-end support design and unique pin gear mechanism provide the following advantages: (1) Capable of ve times the rated torque...

 Open the catalogue to page 2

Rating table Model Speed ratio Allowable thrust load Rated torque Allowable acceleration/ deceleration torque Momentary max. allowable torque Allowable moment Inertia I=GD2/4 (*2) Allowable max. output speed Rotation range Main body weight (*3) Note: The allowable output speed may be limited by heat depending on the operation rate and the ambient temperature. *1: Please refer to the allowable thrust load and allowable moment diagram. *2: The inertia is the value at the reduction gear. The value at the input spline is not included. *3: The main body weight varies with the type of motor. Allowable...

 Open the catalogue to page 3

High-capacity Low-profile Indexer RS-320A • Specifications are subject to change for improvement without notice. External dimension drawing

 Open the catalogue to page 4

High-capacity Low-profile Indexer RS-900A • Specifications are subject to change for improvement without notice.

 Open the catalogue to page 5

New release! RS-260A ● Allowable thrust load 2,500 kg ● Largest cable clearance (through hollow shaft) Ø110 mm in RS series ● Floor to installation surface mounting 335 mm (When removing the base 233.5 mm) Ideal for applications requiring a at conguration when using general smallscale industrial machinery and labor-saving automated equipment No openings for piping or wiring are provided for the lowest oor-mounted unit when the base is removed. Rating table Allowable moment and allowable thrust load RS-260A Speed ratio Allowable thrust load Rated torque Allowable acceleration/ deceleration torque Momentary...

 Open the catalogue to page 6

High-capacity Low-profile Indexer RS-260A • Specifications are subject to change for improvement without notice. External dimension drawing

 Open the catalogue to page 7

Warranty 1. In the case where Nabtesco confirms that a defect of the Product was caused due to Nabtesco’s design or manufacture within the Warranty Period of the Product, Nabtesco shall repair or replace such defective Product at its cost. The Warranty Period shall be from the delivery of the Product by Nabtesco or its distributor to you (“Customer”) until the end of one (1) year thereafter, or the end of two thousand (2,000) hours running of the Product installed into Customer’s equipment, whichever comes earlier. 2. Unless otherwise expressly agreed between the parties in writing, the warranty...

 Open the catalogue to page 8

All Nabtesco Precision Europe catalogues and technical brochures

  1. RV-Gears

    136 Pages

    En
  2. RD2-Gears

    128 Pages

    En
  3. GH-Gears

    36 Pages

    En
  4. RV-N Series

    60 Pages

    En
  5. RD-Gears

    82 Pages

    En
  6. RA-Gears

    32 Pages

    En
  7. Catalogue

    31 Pages

    En

Archived catalogues