Dimensional Measurement of Construction Blocks Using Laser Triangulation Sensors - MTI Instruments - #1

Text version of the page

MTI Instruments, Inc. 325 Washington Avenue Extension Albany, NY 12205 PH: +1-518-218-2550 OR USA TOLL FREE: 1-800-342-2203 FX: +1-518-218-2506 sales@mtiinstruments.com www.mtiinstruments.com APPLICATION NOTE Dimensional Measurement of Construction Blocks Using Laser Triangulation Sensors Introduction Structural building panels, acoustical tiles and manufactured pavers fi t together like the toy building blocks you had as a kid. Remember when your set had a slightly larger or smaller block that caused your creation to collapse? Although not a life or death situation it sure was distressing to see your hard work end up in a pile. Today, manufactured masonry and panel manufacturers face similar problems, however, their liability is much greater. Read on to learn how MTII’s Microtrak II precise measurements drive an automated block qualifi cation system that helps construction block manufacturers increase product quality and reduce product liability. The Problem As construction blocks are installed their structural integrity depends on how well each piece fi ts together. Improvements such as tongue and groove type designs help account for slight variations in dimensional tolerances, however, their strength is weakened by the gaps and spaces created by odd size blocks or defects in the material. To reduce liability, improve appearance and minimize scrap, many manufacturers are looking to control product tolerances tighter than ever before. The Solution A major manufacturer of automated block qualifi cation machines approached MTII looking for a cost effective, high precision laser measurement system for their new generation block qualifi er. Their goal was to incorporate high precision, non-contact sensors into their in-line dimensional inspection system that could provide reliable and “real time” height and width measurements. The sensors had to be non-contact, to eliminate wear and product damage, rugged, to survive the production environment and able to provide high speed digital data output with measurement accuracy to less than 0.005”. Also, sensor output had to meet data transmission protocols previously established by the machine builder’s software and hardware engineers. MTII’s Microtrak II laser sensors were selected to provide the measurements because of their large standoff distance, low cost, fl exible signal output capability, ease of use and their ability to accurately detect virtually any surface produced. The Results The Microtrak II laser heads were incorporated in the new machine without interrupting the customers’ design, production and delivery schedule. Systems have now been installed and are helping block manufacturers’ improve quality, reduce scrap and minimize product liability. MTII appnote: constructionblocks.pdf, page 1 of 1