catalogue search
P. 01
P. 02
P. 03
P. 04
P. 05
P. 06
P. 07
P. 08
P. 09
P. 10
P. 11
P. 12
P. 13
P. 14
P. 15
P. 16
P. 17
P. 18
P. 19
P. 20
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You may also be interested in
Conveyor, Indexer, Handling module, Chain conveyor, Rotary indexer
Text version of the page
| .2. Schematic for Three Phase Model | ||||||||||||||||||||||||||
| Start in Automatic mode -*■ Start in Manual mode Direction Sensor Stop | ||||||||||||||||||||||||||
| Position Reached Ready-to-Start Programmable Cam Position Error | ||||||||||||||||||||||||||
| Warning! All outputs connected to inductive loads must be protected from overvoltage by using diodes. | ||||||||||||||||||||||||||
| Cycle Time Error (flashing) Braking Voltage Error (always 1) | ||||||||||||||||||||||||||
| Reset Error Monitor Braking Voltage VBR -». Operating Mode Measurement Cycle | ||||||||||||||||||||||||||
| Wires to motor max. 20m long | ||||||||||||||||||||||||||
| lonitor Braking Voltage Vbf External Brake Relay Power Supply 3x400V / 50Hz | ||||||||||||||||||||||||||
| A | *!! Warning! If using brakes with a supply voltage of 230VAC or 400VAC, a jumper is NOT allowed between MC and S2. In this case S2 must be connected directly to +24V DC. Braking voltage monitoring is then no longer possible. Hence we strongly recommend a 24V DC brake when using this rotary index table. | ** If a standard 230/400VAC three phase electric motor is interfaced to our single phase rotary index table controller TIC, a Y-connection must be used. Please refer here to the description on the motor terminal block. | ||||||||||||||||||||||||
| A | ||||||||||||||||||||||||||