Catalogs >
Misumi America >
Shafts -Both Ends Tapped-

Shafts -Both Ends Tapped-
1Pages

Catalog excerpts

Please refer to website for current pricing. Shafts -Standard Type / Precision Type- -Both Ends Tapped- ®For Shafts with wrench flats and cross-drilled holes, please see E^R115 ®f8 Shafts not intended for use with Linear Ball Bushings. (*>Annealing caused by machining wrench flats and shaft enc threading (effective thread length + approx. 10mm) may Full Length Hardness Guaranteed Shafts-h- P117 (*}Changes in circularity, straightness, perpendicularity No Surface Treatment on machined areas ®L needs tobeMx2 + Nx2< L®When Mx2.5+4+Nx2.5+4>L, tap pilot hole may go through. Precision Type Standard Type M (Coarse Threads) / N (Coarse Threads) M (Coarse Threads) / N (Coarse Threads) ■Volume Discount Rate I 5-19 I 20- Minimum quoted quantity for precision grade | 10% | 15% shafts larger than 30mm O.D. with low-temp For lnqni qimititi mrim [U| t.. Ship" rricy differ ftom published catabg term.Es- RS7 black chrome plating is 50. ®For D tolerance h5, $4.00 is added to the prices above. |^hjj ®Express T service is net available. -Unlike Type A, Precision Type requires no steps Alteration to L dimension tolerance [Application Notesl Applicable when L=200 or less for precision type When using LKC, L dimensions can be specified in 0.1 increments. Add wrench flats at two locations - [Application Notes| Applicable to D=6 and over g Specify WSC/X in 1 mm increments. ~KT Orientation between wrench flat features is random J5. > Cannot be combined with FC. -10. Add set screw flat at one location [ApplicationNotes) Not applicable to precision type Add set screw flats at two locations [ApplicationNotes) (£>Not applicable to precision type Orientation between set screw flats is random. ~ MSC (Fine Thread) NSC (Fine Thread) DKC Alteration option has been changed to a standard product Type June 2010. Please see new part numbers, SFUW, SSFUW, Change to fine thread tap. Ordering Code] [Application Notes| Applicable to D = 6 or more Add 90-deg. Set Screw Flat at one location [Application Notes] Applicable for D=10-30 Nht applicable to precision type [Application Notes) Applicable for D=10-30 ®Not applicable to precision type Cannot be used in combination with RC. Orientation between set screw features is random. (*)Please see Alteration Guides for details if provided.EST R105 ®For more than one alteration, the distance between machined areas should be greater than 2mm.EiT R106 ^Alterations may lower hardness.EST R104 PSFGW / PSSFGW / PSSFJW / SSFJW / SFUW / SSFUW / PSFUW " Dia. 6 ■ 30 " PSFGW / PSSFGW / PSSFJW/SSFJW / SFUW/SSFUW / PSFUW ** Dia. 4,5,35,40,50 *' VFJW / VSFJW / VPFJW / VPSFJW / VRJW

Open the catalog to page 1