IST-QUADTEK® M353 Retract - Mirion Technologies - #2

2" (51mm) bore with steel rod; Standard

/AL12 -12" (305mm) stroke Optiona:

/AL18 -18" (457mm) stroke /AL24 - 24" (610mm) stroke /AL30 - 30" (767mm) stroke

Minimum 30 psig (207 kPa); maximum inlet presssure 160 psig (1103 kPa)

115/230VAC, 50/60 Hz

-40°F to 160°F (4°C to 71°C)

All aluminum construction; Standard:

/RL42-42" (1067mm) rail /RL30 - 30" (762mm) rail /RL54 - 54" (1372mm) rail /RL66 - 66" (1676mm) rail /RL78 - 78" (1981mm) rail

Clearance envelope; 16.5"W x 13.65"H x 5"D (419mm x 347mm x 127mm)

1/2" NPT female threaded inlet, five mi­cron filter, check valve at inlet to allow one-way air low

Air Hose Aeroquip SH925 (5 meters)

Reservoir stores enough air for 1 retraction of the 30" (762mm) stroke cylinder @ 40 psi (276 kPa)

Automatic retract when air pressure drops below a set level or if power fails. For water cooled lens: Retracts when cooling low drops below a set level. Camera can also be manually retracted and inserted by the operator.

Factory preset to 2.5 psig (17 kPa) min. lens pressure

1 gpm

32°F to 130°F (0° to 54°C)

10"W x 12"H x 5"D (254mm x 305mm x 127mm)

IP66 (prior to modification) to EN 60 529/10.91

Sheet steel, dipcoat primed and pow­der coated in textured RAL 7032

The pneumatic retract is fully inserted into the process.

The pneumatic retract has retracted the lens 12 inches (305mm) from the heat of the process to the end of the cylinder stroke.

The lens and camera have been manu­ally pulled back to the length of the extended rail.