MLT

MS fasteners

Can be installed on both sides MS 45 fastener with screws

Fasteners with self tapping screws: No drilling preparation, no template The screws drill themselves trough the belt Clamping effect of the plates against the belt

MS 25MS 35MS 45 MS 55 MS 65

Belt thickness 3,5 to 7,5 mm 4,5 to 10 mm 6 to 12 mm 9 to 15 mm 10 to 18 mm
(3/32” – 9/32”) (3/16” – 3/8”) (7/32” – 15/32”) (11/32” – 11/16”) (13/32” – 23/32”) Min. pulley Ø 75 mm
(3 ”) 90 mm
(3.5 ”) 125 mm
(5 ”) 250 mm
(14 ”) 450 mm
(18 ”) Belt strengths 450 N/mm 630 N/mm 630 N/mm 1,000 N/mm 1,400 N/mm
(350 PIW) (400 PIW) (400 PIW) (650 PIW) (800 PIW) MaterialScrews made of galvanized steel or non magnetic stainless steel. Fastener made of galvanized steel ornon magnetic stainless steel Galvanizedsteel.
. InstallationBy using an electric screw driver or a hand braceor a pneumatic screw driver (for underground). Hinge materialØ 4,0 mm Ø 4,0 mmØ 7,0 mm Ø 8,0 mm Polyamide covered steel cable or stainless steel cable. Ø 10,0 mm PackagingIn pieces made to measure for requested belt width from 300 mm (1’ ft.) to 3,000 mm (10’ ft) in one piece. ACCESSORIES: Electric screw driver, hand brace, pneumatic screw driver
(underground mines) Screwing bit PZ2, bit holder with magnet