Catalogs >
Miki Pulley Europe AG >
Paraflex Pin Bush

Paraflex Pin Bush
4Pages

Catalog excerpts

PARAFLEX High stiffness High flexibility High damping Max. nominal torque [N·m] Bore ranges [mm] Operating temperature [℃ ] Backlash Drive Easy to mount and remove 25 φ3 ～ 22 －30 ～ 100 Extremely small size Servo motor, stepper motor, induction motor Chip mounters, electric discharge machines, automated teller machines, winders Pin bushing Couplings That Keep Shaft Reaction Force from Mounting Misalignment Extremely Low Pin/bushing style couplings that use aluminum all o y a s t h e ir p r im ar y material. This system makes shaft reaction force due to mounting misalignment extremely small. There is also a damping effect from sliding at the friction surface between the pin and dry metal. Main Features ■ Friction Damping Effect of Pin and Metal Bushing ■ Counterforce from Parallel Misalignment and Angular Deflection is Extremely Small ■ CPU-36-A: Counterforce due to parallel misalignment 4 Metal section Friction damping eﬀects ■ CPU Hub material: Aluminum alloy Hexagon head bolt material: Alloy steel for machine structural use Surface ﬁnishing: Black coating Hub material: Aluminum alloy Clamping bolt material: Alloy steel for machine structural use Surface ﬁnishing: Sol

Open the catalog to page 1

Speciﬁcations Torque Torsional stiffness Moment of inertia [N·m/rad] [kg·m2] SPEED CHANGERS CLUTCHES & BRAKES * Torques for CPE-19 are values when the bore diameter is at least equal to 4 mm. * Max. rotation speed does not take into account dynamic balance. * The moment of inertia and mass are measured for the maximum bore diameter. LINEAR SHAFT DRIVES TORQUE LIMITERS SERIES Metal Disc SERVOFLEX High-rigidity Couplings Metal Couplings Metal Slit Couplings HELI-CAL Metal Coil Spring Couplings BAUMANNFLEX Pin Bushing Couplings * Insert the shaft to at least the dimension L1. (Note that the...

Open the catalog to page 2

CPU Models Speciﬁcations Model Torsional stiffness [N·m/rad] * Max. rotation speed does not take into account dynamic balance. * The moment of inertia and mass are measured for the maximum bore diameter. * Insert the shaft to at least the dimension L1. (Note that the shaft cannot go all the way through.) * The recommended processing tolerance for paired mounting shafts is the h7 class. Standard Bore Diameter Standard bore diameter d1, d2 [mm] * Bore diameters between the minimum and maximums shown in the dimensions table are compatible, but bore diameters other than those shown in the above...

Open the catalog to page 3

Items Checked for Design Purposes ■ Special Items to Take Note of You should note the following to prevent any problems. (1) ind the torque, Ta, applied to the coupling using the output F capacity, P, of the driver and the usage rotation speed, n. (1) Always be careful of parallel and angular misalignment. (2) Always tighten bolts with the specified torque. CLUTCHES & BRAKES SPEED CHANGERS D (2) etermine the service factor K from the usage and operating (1) Couplings are designed for use within an operating temperature range of -30℃ to 100℃ . PARAFLEX couplings are water and oil resistant,...

Open the catalog to page 4

Paraflex Pin Bush 4Pages

Catalog excerpts

All Miki Pulley Europe AG catalogs and technical brochures

Paraflex Pin Bush
4Pages