RPS - 150 Self Contained Sensor
2Pages

{{requestButtons}}

Catalog excerpts

RPS - 150 Self Contained Sensor - 1

RPS-150 Features Adjustable Sensing Range Adjustable Hysteresis Broad Sensing Beam Isolated N.O. N.C. Solid State Relays Limit Switch Style Housing The RPS-150 is a self-contained, wide beam angle ultrasonic sensor. The advantage of this sensor is that the target does not have to be at right angles with the sensor in order to be detected. A flat target can tilt up to 35 degrees and still be detected. For setup purposes an LED indicator is provided. When in the non-detect state the LED is Green and when in the detect state the LED is Red.The RPS-150 can be operated in two modes: a proximity and a hysteresis mode, described below. The frequency of operation is 38.5kHz. There are two ranges available in this model: 2" to 40" or 5" to 80". The sensor is available with a 120VAC power input or a 20 - 30VDC input. It also features a quick disconnect receptacle. The housing is constructed of plastic valox and has standard 30mm X 60mm limit switch mounting dimensions, as well as side holes for mounting the sensor on its side. The output consists of two solid state relays N.O. N.C., and can switch 2 - 130VAC or VDC up to 100mA DC or 50mA AC continuous. The relay outputs are short circuit protected and isolated up to 1500 volts rms. Adjustable Detect Pt. 2" to 40" or 5 to 80" Hysteresis Detection Proximity Detection Proximity Detection Proximity detection is the detection of an object at a given distance. The detection range of the RPS-150 is controlled by the "Range Control" potentiometer. Any object within the desired range is detected, while objects out of range are ignored. The range of the RPS-150 is either 2" to 40" or 5" to 80". This means that in the proximity mode the object will be detected from whatever detect point is set to the minimum sensing range of the sensor, either 2" or 5". The hysteresis control potentiometer needs to be off by turning the pot counterclockwise.

Open the catalog to page 1
RPS - 150 Self Contained Sensor - 2

Specifications: Operational Range: Power Input: Input Current: Ambient Temperature: Transducer Housing:: Plastic Valox Limit Switch Style 2 Solid State Relays N.O. N.C. Isolated 1500Vrms 2 to 130VAC or VDC 100mA DC or 50mA AC Continuous Short Circuit Protected Transducer Frequency: .187" or .5% (.005) of the range, whichever is greater at 70 degrees F. INPUT POWER INPUT POWER Figure: A - Angle of Tilt B - Beam Spread C - Wiring Diag. For RPS-150DC D - Wiring Diag. For RPS-150AC E - Connector Diagram (Male View) F - Mounting Dimensions NOTE: See Page 51 for additional information on "QD"...

Open the catalog to page 2

All Migatron catalogs and technical brochures

  1. RPS-409A-IS3

    2 Pages

  2. RPS-409A-2P

    2 Pages

  3. LCU-40APW

    2 Pages

  4. RPS-409A-2P

    2 Pages

  5. RPS-401/426

    2 Pages

  6. RPS-409A

    2 Pages

  7. RPS-409A-IS2

    2 Pages

  8. RPS-4000

    4 Pages

  9. RPS-150A

    2 Pages