Catalog excerpts
EVERY THING ULTRA SONIC Extract from our online catalogue: pico+TF ultrasonic filling-level sensor Current to: 2023-1 1-13 microsonic GmbH / PhoenixseestraRe 7 / 44263 Dortmund / Germany / T +49 231 975151-0 / F +49 231 975151-51 / E info@microsonic.de microsonic® is a registered trademark of microsonic GmbH. All rights reserved.
Open the catalog to page 1The pico+TF sensors are ideal for the non-contact fill level measurement of chemically aggressive liquids or granules. PTFE membrane IO-Link interface Automatic synchronisation and multiplex operation for protection against aggressive media for support of new industry standard for simultaneous operation of up to ten sensors in close quarters 1 Push-Pull switching output 4 detection ranges with a measurement range of 20 mm to 1,300 mm Temperature compensation for configuration of sensors from a
Open the catalog to page 2Description pico+TF ultrasonic sensors The compact dimensions of the pico+TF sensors makes them ideal for fill-level measurement in housings of restricted dimensions. The ultrasonic transformer is protected against aggressive media by a PTFE film. The exterior PVDF coating with its M22 x 1.5 external thread seals the ultrasonic transformer from the sensor housing. The M22 sensors detect in a contactless fashion and are reliable within a measuring range of 20 mm to 1,300 mm. The ultrasonic sensor is the best choice for non-contact fill level measurement with chemically aggressive liquids or...
Open the catalog to page 3Single switching point Two-way reflective barrier Window mode Teach-in of a single switching point Place object to be detected (1) at the desired distance Apply +UB to pin 5 for about 3 seconds Then apply +UB to pin 5 again for about 1 seconds Teach-in of a switching point Place object at the near edge of the window (1) Apply +UB to pin 5 for about 3 seconds Then move the object to the far edge of the window (2) Then apply +UB to pin 5 again for about 1 seconds Teach-in of an analogue characteristic or a window with two switching points NCC/NOC and rising/falling analogue characteristic...
Open the catalog to page 4indicate the state of the output and support microsonic Teach-in. LinkControl optionally permits the extensive parameterisation of pico+TF level sensors. The LCA-2 LinkControl adapter , which is available as an accessory, can be used to connect pico+TF sensors to the PC. Sensor connected to the PC via LCA-2 for programming Easy to synchronise A number of pico+TF level sensors can be run closely packed in applications synchronised to stop them from influencing one another. To this end, the sync mode has to be activated and all the sensors are to be electrically connected one to another with...
Open the catalog to page 5micro/onic pico+TF ultrasonic filling-level sensor
Open the catalog to page 6scale drawing 1 x Push-Pull measuring range design operating mode particularities ultrasonic-specific means of measurement transducer frequency blind zone operating range maximum range resolution reproducibility accuracy 20 - 250 mm cylindrical M22 lO-Link proximity switch/reflective mode reflective barrier window mode hohe Chemiebestandigkeit PVDF-Gehause schlankes Schallfeld lO-Link echo propagation time measurement 380 kHz 20 mm 150 mm 250 mm 0.069 mm ± 0.15 % ± 1 % (temperature drift internally compensated) electrical data operating voltage UB 10 - 30 V d.c., reverse polarity protection...
Open the catalog to page 7technical features/characteristics temperature compensation controls scope for settings Synchronisation multiplex indicators particularities yes com input Teach-in via com input on pin 5 LCA-2 with LinkControl lO-Link yes yes 1 x LED green: working, 1 x LED yellow: switch status hohe Chemiebestandigkeit PVDF-Gehause schlankes Schallfeld lO-Link The content of this document is subject to technical changes. Specifications in this document are presented in a descriptive way only. They do not warrant any product features.
Open the catalog to page 9scale drawing x analogue 4-20 mA measuring range design operating mode particularities ultrasonic-specific means of measurement transducer frequency blind zone operating range maximum range resolution reproducibility accuracy 20 - 250 mm cylindrical M22 analogue distance measurements hohe Chemiebestandigkeit PVDF-Gehause schlankes Schallfeld echo propagation time measurement 380 kHz 20 mm 150 mm 250 mm 0.069 mm ± 0.15 % ± 1 % (temperature drift internally compensated) electrical data operating voltage UB 10 - 30 V d.c., reverse polarity protection type of connection 5-pin M12 initiator plug
Open the catalog to page 10The content of this document is subject to technical changes. Specifications in this document are presented in a descriptive way only. They do not warrant any product features. pico+TF ultrasonic filling-level sensor
Open the catalog to page 12scale drawing x analogue 0-10 V measuring range design operating mode particularities ultrasonic-specific means of measurement transducer frequency blind zone operating range maximum range resolution reproducibility accuracy 20 - 250 mm cylindrical M22 analogue distance measurements hohe Chemiebestandigkeit PVDF-Gehause schlankes Schallfeld echo propagation time measurement 380 kHz 20 mm 150 mm 250 mm 0.069 mm ± 0.15 % ± 1 % (temperature drift internally compensated) electrical data operating voltage UB 15 V bis 30 V DC, verpolfest type of connection 5-pin M12 initiator plug
Open the catalog to page 13The content of this document is subject to technical changes. Specifications in this document are presented in a descriptive way only. They do not warrant any product features. pico+TF ultrasonic filling-level sensor
Open the catalog to page 15scale drawing 1 x Push-Pull measuring range design operating mode particularities ultrasonic-specific means of measurement transducer frequency blind zone operating range maximum range resolution reproducibility accuracy 30 - 350 mm cylindrical M22 lO-Link proximity switch/reflective mode reflective barrier window mode hohe Chemiebestandigkeit PVDF-Gehause schlankes Schallfeld lO-Link echo propagation time measurement 320 kHz 30 mm 250 mm 350 mm 0.069 mm ± 0.15 % ± 1 % (temperature drift internally compensated) electrical data operating voltage UB 10 - 30 V d.c., reverse polarity protection...
Open the catalog to page 16All Microsonic catalogs and technical brochures
-
crm+25/D/TC/E
75 Pages
-
hps+25/DIU/TC/E/G1
44 Pages
-
mic+ ultrasonic sensors
191 Pages
-
bks ultrasonic edge sensors
13 Pages
-
bks+ ultrasonic edge sensors
10 Pages
-
crm+ ultrasonic level sensors
75 Pages
-
esp-4 label/splice sensor
17 Pages
-
hps+ ultrasonic level sensors
44 Pages
-
LCA-2
11 Pages
-
lcs ultrasonic sensors
33 Pages
-
lpc+ ultrasonic sensors
77 Pages
-
mic ultrasonic sensors
46 Pages
-
mic+ ultrasonic sensors
191 Pages
-
nano M12 ultrasonic sensor
19 Pages
-
nero ultrasonic proximity switch
100 Pages
-
pico+ ultrasonic sensors
78 Pages
-
sks ultrasonic proximity switch
18 Pages
-
ucs ultrasonic sensors
17 Pages
-
wms ultrasonic distance sensors
20 Pages
-
zws ultrasonic sensors
79 Pages
-
cube ultrasonic sensors
33 Pages
-
Online Catalogue ultrasonic sensors
172 Pages