Catalogues - memory-card-interface-data-sheet

Catalogue Memory Card Interface Data Sheet

www.microrobotics.co.uk

Page

/ 4

Contact the
Manufacturer

Where to buy
this product ?

Request
a Quote

/ 4

See all the products Micro-Robotics

Text version of the page

Memory Card Interface

5815

Memory Card Interface Data Sheet Introduction

The 5815 Memory Card interface enables MMC (Multimedia Card) and SD (Secure Data) cards to be used with the Micro-Robotics VM-1 Controller. It can be attached to a Breakout Board (product code 5805) or Application Board 3 (product code 5811) via a short ribbon cable after fitting a suitable header to the application board.

Two different interface options can be used, one offering high speed using the VM-1's serial port 2 connections, the other leaving serial port 2 free for normal use.

The 5815 can easily be mounted on a bracket so the memory card aperture aligns with a front panel slot, or on pillars on a parallel flat surface.

Mechanical

20 way ribbon cable connector

Card dimensions 40 x 60 mm Mounting hole centres 30 x 50 mm

IET LKÎ U(3 U4 in

lUULULLU IT|=|

3 x 2.5mm dia.

UT2 *

5815 Issue A

1 mm overhang

Memory card

Optional LED connection

Note: the Issue B card differs only in component layout. Dimensions and functions are identical.

Connection Kit

A connection kit, product code 5817, is available separately, comprising a short ribbon cable and 20 pin header to mount on a Micro-Robotics application board. You will need this if you do not source these components or their equivalents separately. We do not supply it with the memory card interface because final applications vary in cable length requirements, but we recommend that you purchase at least one for initial development and evaluation ofthe memory card interface.

warning: Users of Micro-Robotics Control Equipment should be aware of the possibility of a system failure, and must consider the implications of such failure. Micro-Robotics Ltd. can accept no responsibility for loss, injury, or damage resulting from the failure of our equipment. Use of ourproducts in applications where their failure to perform as specified could result in injury ordeath is expressly forbidden.

The Old Maltings fax: +44 (0) 1223 524242

135 Ditton Walk sales@microrobotics.co.uk

Cambridge

CB5 8QB www.microrobotics.co.uk

D025 V20070912

5815 Memory Card Interface

Page 1 of 4