| | | PowerPC® System-On-Module EM1N The EM1N is a complete embedded single-board computer for use on any application-specific carrier board. It is designed in accordance with EN 50155 (-40 to +85°C operation temperature, no components on sockets, prepared for conformal coating etc.) The on-board FPGA can be used to add user-defined functions like graphics, fieldbusses, further UARTs etc. C MPC5200B, 384 MHz C FPGA 225,000 gates C 256 MB DDR SDRAM C 8 MB boot Flash, NAND Flash C 2 MB SRAM C 16 MB graphics memory C 2 Fast Ethernet, COM, USB (front) C 2 CAN bus (CANopen) C Stackable with PCI-104 | | PowerPC® PCI-104 Module PP1 The PP1 is a stackable industrial computer board which is designed in accordance with EN 50155 (-40 to +85°C operation temperature, no components on sockets, prepared for conformal coating etc.) C MPC5200B, 384 MHz C 32-bit/33-MHz PCI C 128 MB SDRAM C 16 MB Flash C 64 KB FRAM C 1 Fast Ethernet, 2 UARTs C 2 CAN bus (CANopen) | | This double Eurocard board is used in a safety management system in driverless subways. It is an industrial communication device based on Ethernet and the WorldFIP (Factory Information Protocol) fieldbus standard. The card is at the same time a carrier board for ESM™ Embedded system modules supporting in this configuration an ESM™ with MPC5200 or an ESM™ with MPC8540. C 6U VMEbus master/slave C 1 ESM™ Embedded System Module slot C 1 32-bit/33-MHz PMC slot C 1 CompactFlash® slot C 3 Fast Ethernet (rear) C 4 Ethernet hubs (rear) C 2 FIP fieldbus interfaces (rear) C 5 optically isolated RS422/485 (rear) Q 8 TTL I/O lines C Compliant to EN 50155 | | |