McGill Selection Guide - MCP07-004 - Mc Gill - #1

Text version of the page

™ Cam Follower Selection Guide The trademarks McGILL, CAMROL, CAGEROL, MR, GUIDEROL, LUBRI-DISC, SPHERE-ROL, NYLAPLATE, LAMBDA, TRAKROL, MCFD, MCYRD, MCF, MCFR, MCYR and MCYRR are registered trademarks of Emerson Power Transmission Manufacturing, L.P. and/or McGill Manufacturing Co., Inc. Emerson Power Transmission and McGill Manufacturing are not responsible for printing errors as they may appear in this publication. Bearing specifications subject to change between reprint issues. The Emerson logo is a trademark and a service mark of Emerson Electric Co. © 2007, 2008 Emerson Power Transmission Manufacturing, L.P. or affiliates. All rights reserved. APPLICATION CONSIDERATIONS The proper selection and application of power transmission products and components, including the related area of product safety, is the responsibility of the customer. Operating and performance requirements and potential associated issues will vary appreciably depending upon the use and application of such products and components. The scope of the technical and application information included in this publication is necessarily limited. Unusual operating environments and conditions, lubrication requirements, loading supports, and other factors can materially affect the application and operating results of the products and components and the customer should carefully review its requirements. Any technical advice or review furnished by Emerson Power Transmission Corporation and its divisions with respect to the use of products and components is given in good faith and without charge, and Emerson assumes no obligation or liability for the advice given, or results obtained, all such advice and review being given and accepted at customer’s risk. For a copy of our Standard Terms and Conditions of Sale, Disclaimers of Warranty, Limitation of Liability and Remedy, please contact Emerson Power Transmission customer service, 1-800-626-2120. These terms and conditions of sale, disclaimers and limitations of liability apply to any person who may buy, acquire or use an Emerson Power Transmission Corporation product referred to herein, including any person who buys from a licensed distributor of these branded products. Condition How to identify Potential solutions General Purpose Applications Using an unsealed bearing and desire longer life LUBRI-DISC Seal CF-1-S Can extended bearing life 10 times longer than an unsealed bearing Ease of installation Standard stud type cam followers feature a screwdriver slot to hold bearing during installation Hex-Hole CF-1-S-B Provides superior holding Blind Hole Applications Stud type cam follower installed power into drilled and tapped hole Misalignment/Corner Loading Wear pattern on roller diameter offset from center Crowned OD CCF-1-S Helps to center load Thrust • Thrust loads present • Bearing supports rotating table • Bearing roller develops excessive end play Heavy Duty CFD-3 Incidental thrust loads TRAKROL PCF-3 Higher thrust loads Corrosion • Visible rust • Washdown environment • Bearing lock-up CRES CAMROL ® CF-1-SB-CR Corrosion resistant 440C matrerial Contamination • Dusty or contaminated environment • Bearing lock-up Increased sealing protection: LUBRI-DISC Seal CF-1-S Heavy Duty CFD-3 Special Duty SD-CF-1 TRAKROL PCF-3 Maintenance Free • Bearing difficult to reach • Relubrication not desired Maintenance free options: Bushing Type BCF-1-S Heavy Duty CFD-3 Special Duty SD-CF-1 TRAKROL PCF-3 For Product Information www.emerson-ept.com 407-241-1996 MCP07-004 • 8/07 • Printed in U.S MCP07004 McGill poster.indd 1 2/26/2008 8:26:53 AM