MAX14720 Power-Management Solution
4Pages

{{requestButtons}}

Catalog excerpts

MAX14720 Power-Management Solution - 1

ABRIDGED DATA SHEET MAX14720/MAX14750 General Description The MAX14720/MAX14750 are compact power-management solutions for space-constrained, battery-powered applications where size and efficiency are critical. Both devices integrate a power switch, a linear regulator, a buck regulator, and a buck-boost regulator. The MAX14720 is designed to be the primary powermanagement device and is ideal for either non-rechargeable battery (coin-cell, dual alkaline) applications or for rechargeable solutions where the battery is removable and charged separately. The device includes a button monitor and sequencer. The MAX14750 works well as a companion to a charger or PMIC in rechargeable applications. It provides direct pin control of each function and allows greater flexibility for controlling sequencing. The devices include two programmable micro-IQ, highefficiency switching converters: a buck-boost regulator and a synchronous buck regulator. These regulators feature a burst mode for increased efficiency during lightload operation. The low-dropout linear regulator has a programmable output. It can also operate as a power switch that can disconnect the quiescent load of system peripherals. The devices also include a power switch with batterymonitoring capability. The switch can isolate the battery from all system loads to maximize battery life when not operating. It is also used to isolate the battery-impedance measurements. This switch can operate as a generalpurpose load switch as well. The MAX14720 includes a programmable power controller that allows the device to be configured either for use in applications that require a true off state or for always-on applications. This controller provides a delayed reset signal, voltage sequencing, and customized button timing for on/off control and recovery hard reset. Both devices also include a multiplexer for monitoring the power inputs and outputs of each function. These devices are available in a 25-bump, 0.4mm pitch, 2.26mm x 2.14mm wafer-level package (WLP) and operate over the -40°C to +85°C extended temperature range. Power-Management Solution ● Extended System Battery Use Time • Micro-IQ 250mW Buck-Boost Regulator - Input Voltage from 1.8V to 5.5V - Output Voltage Programmable from 2.5V to 5V - 1.1µA Quiescent Current - Programmable Current Limit • Micro-IQ 200mA Buck Regulator - Input Voltage from 1.8V to 5.5V - Output Voltage Programmable from 1.0V to 2.0V - 0.9µA Quiescent Current • Micro-IQ 100mA LDO - Input Voltage From 1.71V to 5.5V - Output Programmable From 0.9V to 4.0V - 0. 9µA Quiescent Current ● Extend Product Shelf-Life • Battery Seal Mode (MAX14720) - 120nA Battery Current • Power Switch On-Resistance - 250mΩ (max) at 2.7V - 500mΩ (max) at 1.8V • Battery Impedance Detector ● Easy-to-Implement System Control • (MAX14720) - Push-Button Monitoring to Enable Ultra-Low Power Shipping Mode - Disconnects All Loads From Battery and Reduces Leakage to Less than 1µA - Power-On Reset (POR) Delay and Voltage Sequencing • Individual Enable Pins (MAX14750) • Voltage Monitor Multiplexer • I2C Control Interface ● Wearable Medical Devices ● Wearable Fitness Devices ● Portable Medical Devices Ordering Info

Open the catalog to page 1
MAX14720 Power-Management Solution - 2

ABRIDGED DATA SHEET MAX14720/MAX14750 Power-Management Solution Typical Application Circuits 4.7µH HVILX HVOLX BUCK-BOOST Figure 10. Lithium Coin Cell Maxim Integrat

Open the catalog to page 2
MAX14720 Power-Management Solution - 3

ABRIDGED DATA SHEET MAX14720/MAX14750 Power-Management Solution Typical Application Circuits (continued) 4.7µH HVILX HVOLX BUCK-BOOST Figure 13. Companion Li+ Rechargeable Maxim Integr

Open the catalog to page 3
MAX14720 Power-Management Solution - 4

ABRIDGED DATA SHEET MAX14720/MAX14750 Power-Management Solution Ordering Information PART Package Information TEMP RANGE For the latest package outline information and land patterns (footprints), go to www.maximintegrated.com/packages. Note that a “+”, “#”, or “-” in the package code indicates RoHS status only. Package drawings may show a different suffix character, but the drawing pertains to the package regardless of RoHS status. PACKAGE TYPE PACKAGE CODE Refer to Application Note 1891 +Denotes a lead(Pb)-free/RoHS-compliant package. *Future product—contact factory for availability. T =...

Open the catalog to page 4

All Maxim Integrated catalogs and technical brochures

  1. MAX86150

    49 Pages

  2. MAX30208

    29 Pages

  3. MAX30205

    15 Pages

  4. MAX17548

    28 Pages

  5. MAX17521

    22 Pages

  6. MAX17550

    21 Pages

  7. MAX17761

    17 Pages

  8. MAX25615

    9 Pages

Archived catalogs