Text version of the page

DYE PENETRANT INSPECTION Most convenient forField use

Ltd ITW

Vivid red colour requires

flaw detection spray - 21689 SPOTCHECK

No ultra violet light

Division of �

Widely used for weldinspection

R

ED

D

YE

P

ENETRANT

T

ESTING

MAGNAFLUX SPOTCHECK PRODUCTS SKC-S : A volatile petroleum distillate based solvent for removal of surfaceexcess penetrant in a solvent wipe method. Can also be used to removeFlash Point (PMCC)Viscosity at 20 C C7
CS Organic contaminants prior to penetrant testing.Specific Gravity0.72 SKL-SP1 : Deep red penetrant for use with solvent wipe or post removable/Flash Point (PMCC)> 93 C emulsifiable systems. Ideal for testing smooth castings, forgings, fabrications,Viscosity at 38 C3.2
CS welds, etc. both in manufacture and during service.Specific Gravity0.85 SKL-WP : Deep red water washable penetrant ideal for inspection of roughFlash Point (PMCC)> 93 C castings, welds and other rough surfaces where the ease of removal by waterViscosity at 38 C10.0
CS Washing is required,Specific Gravity0.99 SKD-S2 : A suspension of white developer in a blend of volatile nonFlash Point (PMCC)1 C halogenated solvents – SKD-S2 must be agitated thoroughly prior toSpecific Gravity0.92 Application and must be applied by spray. ZR10B : A pink concentrate for dilution in water, 5 to 30% v/v solutions areAqueous solutions will freeze Ideal for removal of excess SKL-SP1 after water pre-rinse. Simpleclose to 0 C all temperatures immersion is sufficient and contact times up to 2 minutes are commonly foundshould not exceed 40 C useful. The above figures are typical values only and do not constitute a Specification