Pelton Wheel flowmeter LM PVC - LITRE METER - #1

Text version of the page

LMPVC+ Series Low cost, plastic bodied Pelton Wheel flowmeter with inline pipe connections, providing a pulse output. Model Type Flow Rate Range Pressure Drop Pipe Size Weight LMPVC.01 0.01 to 0.25 l/min 0.33 bar @ 0.125 l/min; 1.3 bar @ 0.25 l/min ¾” Plain Pipe ends for solvent welding 0.6 kg LMPVC.05 0.02 to 1.3 l/min 0.18 bar @ 0.65 l/min; 0.74 bar @ 1.3 l/min ¾” Plain Pipe ends for solvent welding 0.6 kg LMPVC.24 0.03 to 4.3 l/min 0.3 bar @ 2 l/min: 1.2 bar @ 4.3 l/min ¾” Plain Pipe ends for solvent welding 0.6 kg LMPVC.45 0.04 to 6.3 l/min 0.23 bar @ 3 l/min: 1.3 bar @ 6.3 l/min ¾” Plain Pipe ends for solvent welding 0.6 kg LMPVC.90 0.08 to 15 l/min 0.25 bar @ 9 l/min: 0.7 bar @ 15 l/min ¾” Plain Pipe ends for solvent welding 0.6 kg LMPVC.220 0.1 to 28 l/min 0.24 bar @ 10 l/min: 1.8 bar @ 28 l/min ¾” Plain Pipe ends for solvent welding 0.6 kg Common Features: Pressure Rating Designed for mains water pressure service Temperature Rating 40° C Viscosity Range Up to 10 cPs; ring factory if higher Accuracy ±2% of actual reading for the top 90% of range. ±0.5% FSD for the bottom 10% of range. Repeatability ±0.2% reading over top 90% of range Body and Internals PVC with 316SS with Teflon PFA rotor and sapphire/sapphire bearings Ferrites Sealed Seal FPM ‘O’ ring (subject to chemical compatibility). Wetted parts of sensing electronics 316SS External materials of sensing electronics 316SS or 303SS and anodised aluminium Output & Power NPN open collector with 4-way M12 sensor connector [IEC-61076-2-101] – e.g. compatible with Brad Harrison, Hirschmann, ERNI and Turck Banner. Supplied with 5m cable – bare ends. 8 to 28Vdc input. Options: Output PNP or TTL (identified by green or blue cap respectively). Also divide by 2, 4 or 10 function Connections BSP, NPT, plain od pipe for butt welding or flanges Flow rate, temperature and pressure Alternate ratings available in different sizes and styles, consult factory for further details Seals FEP covered Silicon, EPDM or Kalrez® for chemical protection IS Hazardous Area Version ATEX Available in alternate styles to EEx ia IIC T5 – consult factory for further details (limited to process temperatures up to 70°C) Consult factory for input and output data. Housed in an IP65 epoxy coated die-cast aluminium body-mounted enclosure with 5pin DIN socket. Connection size In certain applications the flow range given above can be obtained with larger or smaller connection sizes - contact factory for details. Documentation: Operating and Maintenance Manual LM0110 with General Information LM0092 Installation Drawing C3679 and general installation C3729 (dimensions as MM20) Conformity: These products conform to PED and EMC. ATEX option available. Flowmeter Specification Sheet