| | | The Max-UP-Ender series is ideally suited for tipping loads up to 90 degrees. Available with capacities of 2,000 lbs to 6,000 lbs and a variety of standard platform sizes. The Max-UP-Enders are also available custom built for those special handling requirements. Designs of open frame, V-block, split platform, and special sizes are just a few of our custom capabilities. | |
| | | • 1-1/2 hp motor. 115/230 volt single phase or 230/460 three phase voltage • A 30 amp dedicated circuit is required for 115 volt operation • Motor is internally mountedonmostmodels • 10'power cord standard (connector not included) • Hydraulic gear pump with check valve, solenoid valve, filter, and velocity fuse standard • Contact factory for special electrical requirements. | | •Highqualitychrome plated cylinders • One, two or three double acting cylinders are supplied based on capacity & table size • Push button magnetic back control box standard with 6' cord • Control box includes magnetic starter transformer, thermal overload and fuses • Powered up and down 90 degree tilt • Tilt limit switch • Color: yellow top with blue frame | | |