OPERATING INSTRUCTIONSEBT 01

100124 ELECTRONIC BRAKE FLUID PROFESSIONAL TESTER - To use for Brake fluid DOT 4 only. With the EBT 01 one measures water content of brake fluid. This measurement is absolutelynecessary to give clear evidence of the condition of the brake fluid that means of the function of the brake itself. If there is too much water in the brake it might come to vapour bubbles which leads to the break down of brakes. Attention: be cautious while testing the brake fluid - can be dangerous to your eyes and skin.Control: Hold bulb of EBT 01 up to the marking into the brakefluid industrial container. Press switch simultaneously 5...10 sec. During entire measuring switch should be pressed and bulb be dipped into fluid The measuring result is shown immediately by the LEDs. Automatically the diodes will light either one, two or all three (see tab). red LED - low batterie: batterie has to be exchange - faulty measurements could be the consequence. IndicationResult

"

green LEDwater between 0 und 1 % brake fluid is all right

""

yellow + green LEDwater about 2%, change brake fluid in short time

"""

red + yellow + green LEDwater is at more than 3% brake fluid has to be changedTechnical Data: batterie : 9 Vbulb: robust material from V4A capillary: 500 mm (20 in.) case: ABS, 120x60x25 mm 4.7x2.4x1in. (L*W*H) Technical modifications reservedD:\GA_GB\EBT01.E 08.11.02 , Ind. 2