Catalogs >
Koike >
ccuFlow3_0802

ccuFlow3_0802
2Pages

Catalog excerpts

Gas Flow Regulator for MIG Welding Exclusive Gas Flow Selector System for MIG Welding The flow rate of the shield gas is adjustable with just a touch versus flow meter type regulators. The Accu-Flow helps to reduce gas waste by allowing the operator to set the exact flow setting quickly and easily, thus preventing excessive use of expensive shielding gas. The Accu-Flow system for MIG welding from Koike Aronson comes in two exclusive types. The electrically heated Accu-Flow CO2 / CWH-30D version and the Accu-Flow Mixing Gas / MIX-30 version are available for your needs. The CHW- 30D thermostatically controlled body heating method insures reliable heat efficiency with quick start-up. The built-in cartridge heater assures safety and durability. Features & Benefits ■ Precise Gas Flow Control This exclusive flow select system allows accurate gas flow control by simply adjusting the dial, saving both time and gas No worries about flow tube needing to be upright to function, ball centering inaccuracies or tube breakage Durable finish on fittings provides corrosion resistance Piston System Design mechanism is free from pressure variation, ensuring high Triple Filters Three inlet gas filters prevent dirt and grit from entering the enough to carry just about

Open the catalog to page 1

Gas Flow Regulator for MIG Welding Inert Coupling Option Flow Rate Setting Scale uses carbon dioxide gas. carbon dioxide and argon. 2) Turn the dial clockwise to increase flow rate gradually. 3) For setting flow rate, match the corresponding scale division of dial with the scale set point. At "0" the gas does 4) Return setting to "0" after use. 5) To terminate operation, close the cylinder valve and discharge gas from inside regulator by turning the dial clockwise then back to "0". If desired disconnect regulator A-Set - Quick Coupling Set for Flow Meter Outlet to Hose B-Set - Coupling Set...

Open the catalog to page 2