Text version of the page

Indexable Insert Assembly for FIX-PERFECT Aluminum Milling Cutters

Introduction to Fitting Cutting Bodies

SOLID CARBIDE 12345 INSERTS Roughing indexable inserts BGHX15L5PC..GG .Finishing indexable inserts BGHX15L5PC..GG.1W FACE MILLS

Clean dust, grease, etc., from the insert seat, insert (1), and clamp stud (2). PMHPM/HSM PM/HPM/HSM

1 Loosen the adjusting element (4). Loosen the adjusting screw (5).
1 Loosen the adjusting element (4). Loosen the adjusting screw (5).
1 Loosen the adjusting element (4). Loosen the adjusting screw (5).
90Ëš MILLS SLOTTING 2 Insert the indexable inserts and tighten with theclamping screw (3). 5 Nm (44 in.-lbs.)Attention: Ensure that the insert is correctlypositioned in the insert seat.
2 Insert the indexable inserts and pre-tighten with the clamping screw (3). 1,5 Nm (9 in.-lbs.)Attention: Ensure that the insert is correctlypositioned in the insert seat.
2 Insert the indexable inserts and pre-tighten with the clamping screw (3). 1,5 Nm (9 in.-lbs.)Attention: Ensure that the insert is correctlypositioned in the insert seat.
DIE AND MOLD Determine which cutting body is the highest on the axis.Determine which cutting body is the highest on the axis. CERAMIC MILLS 3 Tension the adjusting element (4) by tighteningthe adjusting screw (5) to the specified torque of 0,5 Nm (4.5 in.-lbs.)
3 Extract by 0,02 mm (.0008 inch) the insert that is axially the highest by turning the adjusting screw (5).
3 Adjust the finishing indexable insert(s) to thedesired projection (preferably 0,04 mm (.0015 in.) by turning the adjusting screw (5).
CLASSIC MILLS 0,04 mm(.0015 in) Adjust the remaining inserts to the desired run-out with maximum travel of the inserts 0,2 mm (.008 in.). Attention: Ensure that the insert is correctly positioned in the insert seat.
THREAD MILLS 4 Clamp the insert by tightening the clamping screw(3) to the specified torque of 5 Nm (44 in./lbs.).
4 Clamp the insert by tightening the clamping screw(3) to the specified torque of 5 Nm (44 in./lbs.).
TECHNICAL DATA

Attention:

THINK MILLING, THINK KENNAMETAL - 7354 Check the run-out

This process must be repeated whenever an indexable insert is changed.

INDEX

To dismantle, loosen the clamping screw (3) and adjusting screw (5). Then remove the insert (1) with the clamp stud (2).

To place an order, contact Kennametal or your authorized Kennametal distributor, or visit www.kennametal.com.339