Series 8 - KELLER - #2

Text version of the page

Untitled table.main {} tr.row {} td.cell {} div.block {} div.paragraph {} .font0 { font:5.00pt "Arial", sans-serif; } .font1 { font:6.00pt "Arial", sans-serif; } .font2 { font:7.00pt "Arial", sans-serif; } .font3 { font:32.00pt "Arial", sans-serif; } .font4 { font:7.00pt "Georgia", serif; } KELLER Spécifications Excitation I = 1 mA Pressure Ranges (FS) and Overpressure in Bar. Signal Output in mV. PAA-8 10 20 PA-8 10 20 50 100 200 400 600 1000 Signal Output typ.* 225 225 225 225 225 225 225 225 Overpressure 20 40 100 200 300 600 900 1100 PAA: Absolute. Zero at vacuum PA: Sealed Gauge. Zero at atmospheric pressure (at calibration day) * ± 40% Bridge Resistance @ 25 °C n 3500 ± 20% Constant Current Supply mA 1 nominal 5 max. Insulation @ 500 VCC Mn 100 Operating Temperature °C -30.100 -55.150 (optional) Compensated Range °C 0...50(1) -10...80™ Storage Temperature °C -40.100 -60.150 Vibration (20...5000 Hz) g 20 Endurance (FS @ 25 °C) Cycles > 100 x 106 FS Housing and Diaphragm Stainless Steel, AISI 316 L Seal Ring Viton(1), 0 12 x 1,5 mm Oil Filling Silicone Oil(1) Weight 13 g Dead Volume Change @ 25 °C < 0,1 mm3 / FS Electrical Wires (optional) 0,09 mm2, 12 x 0 0,1 mm, Silicone o0 1,2 mm, Length 7 cm(1) Accuracy(2) %FS 0,5 typ.(1) 1 max. --------51 PA-8/1000 bar/8467.8 (a) SN 22747 (b) (c)Temp (d) Zero (e) -510 (f) Comp (g) dZero [°C] [mV] [mV] [mV] [mV] -9.2 -13.3 -7.6 -0.9 -0.4 1.0 -13.4 -7.5 -0.8 -0.3 26.1 -13.7 -7.3 -0.5 0.0 50.8 -14.3 -7.1 -0.3 0.2 80.8 -15.1 -6.8 -0.0 0.5 COMP R2 = 510 kOhm (h) R4 = 27.0 Ohm (h) ZERO -0.5 mV (i) SENS 0.171 mV/bar at 1.000 mA (j) SENS 0.683 mV/bar at 4.000 mA (j) LIN (m) Lnorm (n) Lbfsl (k) [bar] (l) [mV] [%FS] [%FS] 0.000 0.0 0.00 0.14 500.000 85.0 -0.19 -0.14 1000.000 171.1 0.19 0.14 High Pressure Test Ok (o) Lot 5.0412.00 (p) Test 500 Volt Ok (q) Supply 1.000 mA (r) 27.06.06 (s) -----------FLOH.G03CkS (s) Each sensor is delivered with a calibration sheet with the following data: (a) Type (PA-8) and range (1000 bar) of pressure sensor (b) Barcode & serial number of pressure sensor (not standard) (c) Test temperatures (d) Uncompensated zero offset in mV (e) Zero offset values, in mV, with resistance R1 (+) or R2 (-), in kQ (for factory computation only) (f) Zero offset, in mV, with calculated compensation resistors (g) Temp. zero error, in mV, with compensation resistors (h) Compensation resistor values R1 / R2 and R3 / R4 (i) Offset with compensation resistors R1/ R2 and R3 / R4 fitted (fine adjustment of zero with R5 potentiometer) (j) Sensitivity of pressure sensor (k) Pressure test points (l) Signal at pressure test points (m) Linearity (best straight line through zero) (n) Linearity (best straight line) (o) Results of long term stability (p) Lot (on request, identification of silicon chip) (q) Voltage insulation test (r) Excitation (constant current) (s) Date of test --------Test equipment Remarks: - The indicated specifications only apply for constant current supply. The sensor should be excited between 0,5 and 5 mA. The sensor signal is proportional to the current. - If exposed to extreme temperatures, the compensation resistors should have a temperature coefficient of < 50 ppm/°C. Sensor and resistors can be exposed to different temperatures. - The sensors may be ordered with integrated compensation resistors (surcharge). Offset at 25 °C mV Temperature Error - Zero mV / °C - Sensitivity % / °C Long Term Stability typ. mV Natural Frequency (Resonance) kHz < 5 mV (compensated with R5 of 20 n(3)) 0...50 °C < 0,025 < 0,02 0,5 > 30 -10...80 °C < 0,05 < 0,05 0,75 -55...150 °C < 0,075 < 0,07 1,25 (1) Others on request. (2) Including linearity, hysteresis and repeatability. Linearity calculated as best straight line through zero. Note: Generally, accuracy and overload is improved by factor of 2 to 4 if the sensor is used in the range of 0...50 %FS. (3) External compensation, potentiometer not supplied. Options - Platinum- or Hastelloy C-276 diaphragm. Gold-plated diaphragm. Transducer all Hastelloy C-276 - Oil for low temperatures. Fluorinated oil. Olive oil - Special characteristics: Linearity, overpressure, lower TC-zero - Special tests - All pressure ranges between 10 and 1000 bar - Other temperature ranges - Compensation PCB fitted Subject to alterations 02/07 KELLER AG fur Druckmesstechnik St. Gallerstrasse 119 CH-8404 Winterthur Tel. +41 (0)52 - 235 25 25 Fax +41 (0)52 - 235 25 00 KELLER Ges. fur Druckmesstechnik mbH Schwarzwaldstrasse 17 D-79798 Jestetten Tel. +49 (0)7745 - 9214 - 0 Fax +49 (0)7745 - 9214 - 60 Companies approved to ISO 9001:2000 www.keller-druck.com