HMC500 Horizontal Machining Center
1Pages

X-axis Travel mm 720 720 Y-axis Travel mm 650 650 Z-axis Travel mm 650 650 Distance from spindle center to table surface mm 100-750 100-750 Distance from spindle nose to table center mm 150-800 150-800 Table Dimension mm 500x500 500x500 Number of table 2 2 Loading capability kgs 800 (Uniform load) 800 (Uniform load) Working dimension ( diameter/ height ) mm 700/800 ؘ700/800 Table(Pallet) top surface configuration 24-M16 24-M16 Minimum index division of table (pallet) degree 0.001 (*1а) 0.001 (*1а) Table (Pallet) indexing time (0~90) sec 2.5 2.5 10,000 Direct-driven 6,000 Direct-driven(*10,000 Spindle speed rpm (*15,000 Built-in) Built-in) Numberof spindle speed change steps 2 steps (MS) 2 steps (MS) Spindle main bearing bore diameter mm И70 100 Rapid travel rate ( X,Y, Z ) m/min 24 (*48) 24 (*48) Cutting speed rate( X,Y, Z ) m/min 10 10 Spindle Nose No.40 7/24 taper No.50 7/24 taper Typeof tool shank BT-40/CAT-40 BT-50/CAT-50 Magazine capacity 40 (*60,*90,*120) 40 (*60,*90,*120) Max. tool diameter mm ؘ95 125 Max. tool diameter ( without adjacent tools ) mm ؘ190 250 Max. tool length mm 350 400 Max. tool weight kg 8 20 Shortest distance, absolutely Shortest distance, absolutely Tool selection method method method Tool change time ( tool to tool ) sec 2.4 (*1.6) 3 (*1.8) Tool change time ( chip to chip ) sec 6 (*3.5) 8 (*4.0) Pallet change method Direct turn method Direct turn method Pallet change time ( APC only ) sec 11 (*6) 11 (*6) (10,000 rpm) (6,000 rpm) kW 11/15 15/18.5 Spindle motor (30min/continuous) kW (*15,000 rpm) (*10,000 rpm) 18.5/22 25/30 Feed motor (X ) kW 7.0 7.0 Feed motor (Y ) kW 6.0 6.0 Feed motor ( Z ) kW 4.0 4.0 Feed motor ( B ) kW 4.0 4.0 Hydraulic pump motor kW 3.75 3.75 Motor for spindle feed system oil cooler(compression/discharge) kW 2.3/0.75 2.3/0.75 Coolant pump motor kW 0.2x1, 0.4x2 0.2x1, 0.4x2 Power supply AC200V / 220V kVA 40 (*50) 45 (*55) Compressed air supply MPa, l /min 0.4~0.6, 500 0.4~0.6, 500 Hydraulic unit tank capacity l 120 120 Spindle feed system cooling oil tank capacity l 36 36 Coolant tank capacity l 370 370 Controller model ST. Fanuc0iC, Mitsubishi M64 Fanuc0iC, Mitsubishi M64 OP. Fanuc18iM, Mitsubishi M65 Fanuc18iM, Mitsubishi M65 Floor area mm > 2 4,035x6,385 4,035x6,385 Machine height mm 3,105 3,105 Machine net weight kg 13,000 13,000 >