Text version of the page

Design Guidelines

Determining the chain length L

k The calculation of the chain / conduit length is done in the same way as for the arrangement one-sided.

and / or conduit length L

ESfor opposing arrangement of the cablecarrier It is absolutely necessary to pay attention to the fact that wherethere are two moveable applications with a common driver, bothcable carriers must be of the same width!

Design note:

The support construction of the guide channel must be designedwith the necessary stability to guarantee a clean height separation between the active upper run and the passive lower run, especially where there is a lower driver connection. ”Technical data – dimensions of the guide channels”

→

see accessories The achievable length of a system depends on the following parameters:

→

the load to be moved (intrinsic weight + additional load)

→

acceleration

→

travel speed

→

travel frequency

→

gliding friction coefficient

→

the permissible tensile force of the cable carrier Because of the many design parameters which need to be consid- ered such an installation as this should be planned and designed by our engineers! In this case please use the telefax questionnaire, which you will find inthe Appendix to this handbook or send us an eMail to info@kabelschlepp.de

Note:

For very long travel lengths and / or other extraordinary conditions whichdo not permit the installation of a gliding plastic cable carrier system, KABELSCHLEPP can also supply portable support devices. Our engineers will be pleased to design a suitable solution for your application.
2.14 We reserve the right to make technical changes!