Text version of the page

Technical Data — KSeries

Type KE 0900

Version A Version B

Notch in connectingprofile to the inside (Standard)The dividers can slidealong the section. Notch in connectingprofile to the outside

Divider systems

The divider system can be planned by youor by our engineers on the basis of the information you supply about the configura- tion of the cable carrier.As standard, the divider system is fitted onevery frame stay (with stay assembly on every 2nd chain link).

The dividers are fixed in the section (

a

x

-grid

16 mm)

Divider system TS 0

Dividers can slide along the cross-section (Version A) or are fixed(Version B). For divider version B please state fitting intervals a without height subdivisionWith version B a

T

and a

x

!

Version A Version B s
T 6 mm6 mma
Tmin 7.5 mm8.5 mma
x min 14.5 mm16 mma
58 xgrid continuous16 mm
sT x

must be divisible by 16!Please state the type and the number of dividers/cross section n

KR a TL a x a TR T

when ordering.For version Adividers with s

B i T

= 4 mmare also available. Sample order: Divider system TS 0-A/ n

T

3

Divider system TS 1

Technically recommended variants: VR 1, VR 4, VR 5 and VR 45 Dividers can slide along the cross-section (Version A) or are fixed (Version B). For divider version B please state fitting intervals a with grid subdivision (1 mm grid)Height subdivision: Al-Profile 11 x 4 mm

T

and a

x

!

16 16 16 27 6 38 4 77 2 11 1 22 3 38 5 27 7 16 16 16 KR a TL a a Position of the sub-division(s) in the divider x s T TR B i Version A Version B

Please indicate the cavities (from left to right), the relevant subdivision variant and the assembly spacing a

s
T 6 mm6 mma
T

and a

x

when ordering.For version Adividers with s

Tmin 24.5 mma
Tmax 25mm24.5 mma
T

= 4 mm are also available.

x min 14.5 mm16 mma

Sample order: Divider system TS 1– VD 55/n

T

5

xgrid continuous16 mmn
Tmin 2 2 3.310
Subject to technical changes! KE