Fittings

Flow-through fittings Manual quick-change fittings

Further information: Data Sheet 20.2810 Flow-through fittings are used for holding electrochemicaltransducers (e.g. pH and redox combination electrodes, glass conductivity cells, compensation industrial thermometers etc.) with a Pg13.5 screw thread and a mounting length of 120mm. Fitting types are available for 1 to 3 transducers. The fittings are mounted directly in the feed lines of the substance being measured, or in bypasses. They protect the installed sensors from breakage and, thanks to their special construction, prevent measurement errors by ensuring the correct incident flow on the sensor. Various mounting methods and materials are available. Further information: Data Sheet 20.2822 Manually operated quick-change fittings make it possible toremove and replace the sensors under process conditions, i.e. the circulation or main feed that is concerned does not have to be interrupted.The principal areas of application for quick-change fittings arein closed circulation systems or measurement in the inlets or outlets of wastewater systems. Quick-change fittings can also be mounted in the side walls of containers - in this case, a sensor can be removed without first having to empty the container. The fittings enable the mounting of sensors with a Pg13.5 thread and a mounting length of 120 or 225mm

Immersion fittings Stainless steel process fittings

Type 202825 Type 202831 Further information: Data Sheet20.2820 Further information: Data Sheet 20.2825 Immersion fittings are used for holding electrochemicaltransducers (e.g. pH and redox electrodes, glass conductivity cells, compensation thermometers etc.) with a Pg13.5 screw thread and a mounting length of 120mm. Fitting types are available for 1 to 3 transducers. The fittings are mounted in open sluices or containers. They protect the installed sensors from breakage, and permit measurement at various immersion depths. Options and accessories make it possible to adapt the fittings to match the application conditions. The standard versions use two pipe clamps for wall mounting, but optionally available sliding flanges also permit mounting in container lids and the like. These fittings are used to mount and protect the transdu-cers. They can be installed directly in existing stainless steel piping systems or in the walls of containers. Type 202825 fittings are primarily used in processing installations that are subject to enhanced hygienic requirements. The parts in contact with the medium, and the sealing materials that are used, comply with the requirements of the FDA (Food & Drug Administration). Type 202831 fittings are primarily used in water engineering and process technology. Both types of fitting are intended to be used for installing sensors with a length of 120mm