ip36-80ds intensifier pump Intensifier · Output Pressure: 36,000 psi (2500 bar) or 40,000 psi (2757 bar) continous · Number of intensifiers: 1 · 12:1 Intensification ratio · Flow rate: 1.8 gpm (6.8 L/m) at 36,000 psi or 1.6 gpm (6.05 L/m) at 40,000 psi · Maximum Rated Orifice: .022 in (.56 mm) at 36,000 psi or .020 in (.51 mm) at 40,000 psi Engine · Engine output: 80 hp · Engine type: Cummins 4 cylinder turbocharged diesel (meets Tier 3 certification) · Fuel Tank: 27 U.S. gal (100 L) · Cooling: Air cooled circulating water (radiator) Hydraulic · Pump type: Axial piston, variable displacement, pressure compensated · Pressure rating: 3,200 psi (220 bar) · Cooling: Air over oil heat exchanger · Filtration: 10 micron kidney loop; 13 gpm at 1800 rpm (49 L/m) · Fluid capacity: 25 U.S. gallons (95 L) · Fluid type: Standard: medium grade turbine ISO Standard Features • A Programmable Logic Controller (PLC) operates the electronic timing of the intensifier cycle • 1.0 quart (0.9 liter) high pressure attenuator stabilizes operating pressure • Automatic safety pressure bleed-down valve relieves pressure from system • On-board Water Prefilter to 1 micron • Hydraulic accumulator dampens hydraulic fluid pulsations • Full flow hydraulic filtration to 10 micron increases hydraulic component life • Air cooled hydraulic fluid • Safety shutdown systems • Skid design Optional Features • CE Mark Physical size · Length: 88 inches (2235 mm) · Width: 64 inches (1625 mm) · Height: 65 inches (1650 mm) · Weight: 3,500 lb (1590 kg) dry Environmental · Ambient temperature: 50-95ºF (10-35º C) · Relative humidity: Non condensing, maximum 95% at 100ºF (38ºC) Low Pressure Water · Input Pressure: Minimum pressure 40 psi (3 bar) at 7 gpm (26 L/m) · Input temperature: Maximum temperature 70ºF (21ºC) · Filtration: Two filters, 10 micron and 1 micron