AKKUTEC 2412C - 4 Pages

  1. P. 1

  2. P. 2

  3. P. 3

  4. P. 4

Catalogue excerpts

Datasheet Battery buffered power supply in parallel operation (On-Line) for internal batteries protective system IP 31 manufacturer: J. Schneider Type : AKKUTEC 2412C Art.-No. : NBPG0812G01001 Short description The battery buffered DC power supply is working according the stand-by parallel mode and ensures in connection with a lead-acid accumulator a safe continuous DC power supply during a determined time interval in case of mains failure. The total output current is shared between supply of the loads and charging of the batteries. Batterie-Selection designation Akku 12 V / 26 Ah

 Open the catalogue to page 1

J. Schneider Elektrotechnik GmbH J. Schneider Elektrotechnik GmbH info@j-schneider.de Postbank, Karlsruhe BLZ 66010075 Kto. 44 58-753 www.j-schneider.de Dresdner Bank, Offenburg BLZ 68080030 Kto. 0720406100 Geschaftsfuhrer: Dipl.-Betriebswirt (BA) Bettina Schneider ■ Dipl.-Wirtsch.-lng. (FH) Rolf Anti ■ Amtsgericht Freiburg HRB 470758

 Open the catalogue to page 2

Displays Betrieb/Operation Störung/Fault LED green, illuminates as long as the output voltage is present LED yellow, illuminates at fault: battery operation, battery low, triggering of fuse LED green, illuminates at mains operation UE > UEmin and TInt < TIntmax LED green, illuminates at UBat > 21,6V, expires at UBat < 21,6V, battery circuit interrupted respectively high-resistive (test interval 60s) Ua DC/DC Control Störung / Fault Betrieb / Operation Störung / Fault Current Share CS (Master/Slave) Sync (Master/Slave) Eingang / Input

 Open the catalogue to page 3

Technical Data Nominal voltage: 230 VAC (-15% / +10%) Mains frequency: 47 Hz bis 63 Hz Power consumption: 380 VA, max. Input current 1.8 A (bei 12A Ausgang) Inrush current: 35 A / 2 ms, max. Output voltage: 24 VDC (21,6 … 28,3V ±0,4%) Nominal output current (incl. battery charging current according to VdS):12 A, max. Deep discharge protection and load rejection: 20,4 VDC, ± 0,4% Final charging voltage: 27,4 VDC, ± 0,4% (bei 25°C) efficiency: 89 % contact load relay: 30 VDC / 0,5 A, potential-free relay-contact type of battery: lead acid battery, maintenance-free environmental temperature: -5°...

 Open the catalogue to page 4

All J. Schneider Elektrotechnik catalogues and technical brochures

  1. SPS Advance RT

    2 Pages

    En
  2. MLT C 10 - 20

    10 Pages

    En
  3. UCC - TEC 450

    2 Pages

    En
  4. NCBG1115G01002

    4 Pages

    En
  5. NCBG1138G01001

    2 Pages

    En
  6. AKKUTEC 2403C

    5 Pages

    En
  7. C-TEC 1203-1

    1 Pages

    En
  8. UNOTEC 2420

    2 Pages

    En
  9. UNOTEC 2405N

    2 Pages

    En
  10. CEM12V12

    1 Pages

    En
  11. CEM1

    1 Pages

    En
  12. AC-C-TEC 2403-05

    1 Pages

    En
  13. C-TEC 2408-20

    1 Pages

    En
  14. AKKUTEC 2410-0

    2 Pages

    En
  15. AKKUTEC 2403

    2 Pages

    En
  16. AKKUTEC 2403 DC

    2 Pages

    En
  17. C-TEC 2403-05

    1 Pages

    En
  18. AKKUTEC 2405

    2 Pages

    En

Archived catalogues

  1. DC-UPS systems

    16 Pages

    En
  2. Focus on

    16 Pages

    En