Text version of the page

Technical Data Sheet Permatex



PermaPoxy  Clear General Purpose Epoxy Products

INDUSTRIAL PRODUCT DESCRIPTION 2. Surface must be clean, dry and free of grease & oil. 3. Roughen surfaces with sandpaper or other abrasives. 4. Hold the lower half of pouch between thumbs and forefingers and press firmly to break inner seal. 5. Quickly and thoroughly mix until the blue color turns clear (about 15 seconds). 6. Tear open pouch and apply small amount of mixture to both surfaces and assemble parts immediately (product sets up in about 60 seconds). 7. Remove excess epoxy immediately with mineral spirits or acetone. 8. Usable strength is reached in 4 hours at 72ºF (22ºC). Cooler temperatures may require a longer set time Permatex
 PermaPoxy ï›› products are two part, clear epoxy adhesive systems. PermaPoxy ï›› Clear General Purpose epoxies are of a maximum strength formula that is available in several working times. PermaPoxy ï›› is ideal for complex, multi-piece assemblies. They are water and solvent resistant and available in dual syringes or tubes. PRODUCT BENEFITS • Will not shrink • Various curing cycles • No clamping needed NOTE: Adhesive will not bond most 1. For any cleanup, use isopropyl alcohol before the material is allowed to dry. 2. Clean hands with Permatex • Fills gaps • Nearly colorless p ol y eth y lene or polypropylene plastics. • Impact resistant • Water resistant For Cleanup TYPICAL APPLICATIONS To bond rigid materials including: • Chrome
 Fast Orange
® hand cleaner or soap and water. • Fiberglass • Glass • Plastic PROPERTIES OF UNCURED MATERIAL • Metal
Typical Value DIRECTIONS FOR USE 1. Protect work area from accidental spills. 2. Surface must be clean, dry and free of grease & oil. 3. Roughen surfaces with sandpaper or other abrasives. 4. Use a sharp blade to cut off the tips of both nozzles. 5. Depress plunger on syringe or squeeze out of tubes equal amounts of resin and hardener from tubes. Thoroughly mix resin and hardener on a clean discardable surface for at least one (1) minute (20 to 25 seconds in the case of the one minute epoxy) or until uniform in color.
Chemical Type Epoxy and Mercaptan or Amine Resins Mix ratio (volume) 1 : 1 Appearance Resin Hardener Clear Clear Odor Mild Specific Gravity 1.10 - 1.17 Flash Point, TCC >200ºF Viscosity Heavy syrup CURING PROPERTIES Working Time Fixture Time 82516 50-60 seconds 2 – 4 minutes 82517 4 – 5 minutes 8 – 10 minutes Final color Clear to slightly yellow Temperature range -60 ° F to +180 ° F GENERAL INFORMATION This product is not recommended for use in pure oxygen and/or oxygen rich systems and should not be selected as an adhesive for chlorine or other strong oxidizing materials. For safe handling information on this product, consult the Material Safety Data Sheet, (MSDS). 6. Apply to surfaces being repaired. Assemble parts immediately. Remove excess epoxy immediately. 7. Allow bond to set for the fixture time before moving. DIRECTIONS FOR SINGLE USE POUCH 1. Protect work area from accidental spills.
NOT FOR PRODUCT SPECIFICATIONS. THE TECHNICAL DATA CONTAINED HEREIN ARE INTENDED AS REFERENCE ONLY. PLEASE CONTACT ITW DEVCON TECHNICAL SERVICE DEPARTMENT FOR ASSISTANCE AND RECOMMENDATIONS FOR YOUR SPECIFIC APPLICATION. ITW DEVCON, 30 ENDICOTT STREET, DANVERS, MA 01923 PHONE – (1-978-777-1100) Revised 04/09