Flexane® Fast Cure Rubber Repair Putty - ITW Devcon - (Version JPG) - Page n° 2 - PDF Catalogue | Technical Documentation

Mix until color is uniform and consistent (approx 4-6 min.), while continuously scraping material away from sides and bottom of container.

NOTE: Completely submerge propeller, otherwise large amounts of air will be added resulting in air bubbles on the finished product's surface.

Application Instructions:

1. Mount cartridge onto manual gun (#15043) or pneumatic gun (#15041).

2. Attach #15047 mix nozzle (used with both cartridges).

3. Clip mix nozzle back to desired orifice size.

4. Squeeze cartridge, allowing first THREE INCHES of material to discharge until a unified mix is exuding from nozzle, (color is uniform with no striations).

5. Finish application as quickly as possible.

IMPORTANT:

Replace mix nozzle every four minutes to ensure complex mix, with no soft spots. Because of the short pot life (8 minutes), stopping between uses can result in Flexane product curing IN the mix nozzle. Further mixing will be off ratio.

Store at room temperature. None

Chemical resistance is calculated with a 7 day, room temp. cure (30 days immersion) @ 75°F)

Storage: Compliances:

Chemical Resistance:


1,1,1-Trichloroethane	Poor	Phosphoric 10%	Very good
Aluminum Sulfate 10%	Very good	Potassium Hydroxide 40%	Very good
Cutting Oil	Fair	Sodium Hydroxide 50%	Very good
Gasoline (Unleaded)	Poor	Sodium Hypochlorite	Very good
Hydrochloric 10%	Very good	Xylene	Poor
Hydrochloric 36%	Very good
Isopropanol	Poor
Methyl Ethyl Ketone	Poor

Precautions:

Warranty: Disclaimer:

Please refer to the appropriate material safety data sheet (MSDS) prior to using this product. For technical assistance, please call 1-800-933-8266 FOR INDUSTRIAL USE ONLY

Devcon will replace any material found to be defective. Because the storage, handling and application of this material is beyond our control, we can accept no liability for the results obtained.

All information on this data sheet is based on laboratory testing and is not intended for design purposes. ITW Devcon makes no representations or warranties of any kind concerning this data.

15049 400 ml cartridge

Order

Information:

ITW Devcon, 30 Endicott Street, Danvers, MA 01923 Tel:(978) 777-1100 Fax:(978) 774-0516 www.devcon.com

Flexane® Fast Cure Rubber Repair Putty - ITW Devcon - #2

Two-component adhesive, Silicone adhesive, Polyester adhesive, Oil sorbent, Degreaser