Hydrosteel 6000 Brochure - ION Science - #4

Text version of the page

HYDROSTEEL 6000 TECHNICAL SPECIFICATION MEASUREMENT PRINCIPLE Hydrogen collection and analysis INTRINSICALLY SAFE APPROVALS II 2 G EEx ia IIC T4 -20 °C Ta 60 °C Baseefa 02ATEX0093 OPERATION Battery Type: 4 x Alkaline AA. Typically 30 hours life DC input 6 volts SENSITIVITY ± 1 pL/cm2/s (Note: 1 pL = 10-12 litres at s.t.p.) DYNAMIC RANGE 0 to 15,000 pL/cm2/s ACCURACY ± 10% display reading ± one digit RESPONSE T90 = 50 seconds CALIBRATION Certified to international UKAS/NIST standards Yearly calibration required COMMUNICATION Bi-directional using IR port DATA LOGGING Over 40,000 data points with time & date stamp PC SOFTWARE Microsoft Windows and Vista compatible TEMPERATURE Analyzer: -20 to 50 °C, -13 to 120 °F LT-R probe: steel surface up to 150 °C, 300 °F HT-R probe: steel surface up to 500 °C, 930 °F AT-S probe: steel surface up to 500 °C, 930 °F HT-S probe: steel surface up to 500 °C, 930 °F Storage < 20 °C, <70 °F GAS CONDUIT Standard lengths available: LT-R and HT-R 1 - 10m LT-R only 2m DIMENSIONS Analyser: 13.5 x 2.3 x 2 in., (34 x 6 x 5 cm) LT-R and AT-S probes: 6 in., (15 cm) diameter HT-R and HT-S probes: 2.25 in., (5.7 cm) diameter WEIGHT Analyser: 1 lb, 450 g LT-R probe: 14 oz, 397 g HT-R probe: 11 oz 312 g STEEL CUVATURE RANGE Minimum diameters LT-R and HT-S probes: 3.5 in., 9 cm HT-R and AT-S probes: 8 in., 20 cm EMC tested EN50081-1 & EN50082-1 July 98 ION SCIENCE is ISO9001:2000 certified (December 2003) Part number HS6V1.1 This publication is not intended to form the basis of a contract and specifications can change without notice. For further information and ordering please call: Tel: +44 (0) 1763 208 503 Email: info@ionscience.com www.ionscience.com ION SCIENCE LIMITED The Way, Fowlmere, Cambs. SG8 7UJ, UK Hydrosteel technology is also available in a fixed monitor, Hydrosteel 7000, used for continuous corrosion measurements at highly critical sites. Easy to install and non-intrusive, Hydrosteel 7000 can be permanently attached to steel in petrochemical service up to 500 °C, 930 OF. Data is stored internally and communicated via a 4-20 mA output every 10 minutes, ensuring immediate awareness of any change in active corrosion. Dependent upon application Hydrosteel 7000 can give a direct corrosion rate indication in mm/yr or mils/yr. Specialised software collates information regarding the hydrogen flux and steel type, temperature and thickness to calculate a corrosion rate in real-time.